VE Commodore Tune

[thecardoc]

Hey guys, would anybody be able to help out with a strong tune for a VE Commodore L98 6.0L, has had a Cam, attached is full HPT read and cam specs,
thanks

[kevin87turbot]

That's a pretty mild cam for a 6.0L, so it'll be easy to get it to idle and run properly.
Here's a quick synopsis of the steps that will get it running.

1. Go to Engine>Airflow>Dynamic tab and lower the High rpm disable/re-enable to 400/300 respectively.
2. Go to Engine>Idle>RPM tables and Add 150 rpm to the four idle rpm tables.
3. Go to Engine>Idle>Airflow tables and add 3.5 gms/sec to the Airflow Final Min table
4. Go to Engine>Idle>Airflow and increase the startup airflow by 25%.
5. Go to Engine Diag>Airflow tab and change Min ECT for P0101 to 256, and change Airflow Correlation RPM from 800 to 8000.
6. Go to Engine Diag>Misfire tab and change Min misfire detection enable to 2500 rpm.

That'll get it running nicely until you have time to get it to your tuner.

[THE CHAD]

Hey guys, would anybody be able to help out with a strong tune for a VE Commodore L98 6.0L, has had a Cam, attached is full HPT read and cam specs,
thanks

..........One question mate are you going to tune this yourself ? and want some help or advice/learn?...or do you have a tuner in mind thats going to tune it for you, cause without being negative bud good luck finding someone on here to supply you with a good tune especially if you are taking it to a tuner etc...