Was in the middle of a flash and the computer fell asleep. Then I got a controller timed out message and now I can?t read or write anything to it. Wasn?t sure if there was anything I could try
Was in the middle of a flash and the computer fell asleep. Then I got a controller timed out message and now I can?t read or write anything to it. Wasn?t sure if there was anything I could try
email support they can help but it will take a few days, my 03 did the same and they got it going
2010 F-350 03 5.9/848ecm, built 5R110, 30% over sticks, 10mm pump, 64mm Stealth Turbo
2008 F-350 03 5.9
Fumminstuning.com
I left the battery charger on the truck disconnected from the obd port and shut the key off. Let it sit for 20 minutes and it full flashed!
you are super lucky
2010 F-350 03 5.9/848ecm, built 5R110, 30% over sticks, 10mm pump, 64mm Stealth Turbo
2008 F-350 03 5.9
Fumminstuning.com
Just had same issue as OP stated, any insight on how to fix? Numerous tries to continue flash only resulting in timing out. Thanks
Disconnect both batteries and wait an hour. While waiting hook them up to a battery charger.
Pull the fuel pump relay when flashing a tune. Have the computer connected to the obd port but turn the key to the run position first before opening the tune file.
Mine times out a lot when it's not warmed up. I also have better luck when I hook a battery charger to it during the flash. Sometimes when it gets the ecm stuck in the middle of the tune, I just have to keep hitting write and eventually it will take. It take 50 times of trying sometimes.
2004.5 Cummins.
Borgwarner 13009097047 s300sxe 63-73 compressor 63/80 super core turbine housing 80mm .83 A/R Twin Scroll Housing,
50HP BMS/Exergy Injectors
BD T4 manifold,
BD CAI,
5" turbo back exhaust,
turbosmart ext wastegate,
BD lift pump with 2 mic filter and h2o separator,
banks intercooler, Banks intake horn,
slightly built tranny.......
Reply With Quote