Good afternoon, need some Advice or assistance, did a turn about 2
Months ago, removed the catalyst codes and o2 codes for the CEL , they had put
The headers on prior and drove For a month before Tune, but now 2 months later all codes came up again and CEL is there anything we might have missed or what?s the correct
Measure to Correct this issue
Any criticizing
Or help is appreciated !
What are the codes?? That be a good starting point
Email Tunes, [email protected]
96 TA Blown/Stroked, 4L80E/Fab 9
15 C7 A8 H/C 2.3 Blower/PI
14 Gen 5 Viper
Custom Mid Engine chassis, AKA GalBen C
I guess it didn’t add it sorry
P0031
p0451
p0137
p0420
p0135
p0161
I would add your calibration file too, pretty easy to see if these DTCs are turned on or offOriginally Posted by pastuned
I think I found it it was a gas cap on the P0451 code but it’s weird I had removed the other codes and unchecked the SES and out no error reported and comes on when they went to autozone is it a permanent code then on those ?
I had to reroute my wire harness (after repairing it) because the passenger side headers were making contact and burning through insulation. Caused shorts and several faults. I ended up routing behind the coolant overflow tank. I'm thinking the heat from the headers softened the harness enough to relax and make contact. Took a while though.
Reply With Quote