I have a 2005 GTO putting a new (used) PCM in and cant get the vin change to work. Both PCMs have the same #'s on them 12596733 & 12597191
I have tried the vin change and hit commit did the wait 15 seconds and then 30 seconds on/off 2 times
I did a write entire
The car will not even turn over with the new PCM
Am I missing a step some where
Any help is greatly appreciated
You need a Tech2/MDI and SPS.
Have you tried the 30 minute VATS relearn? Not sure if that will work on a GTO because they are really Australian and have their oddities bit it's worth a try.
Thank you guys
The E40 PCM VIN must be changed through the VCM Scanner. Not the editor. Hope this helps.
2009.5 PBM G8 GXP M6 W/Roof-Self tune, OBX LTs, Kooks axleback, LSA blower, cam,
Monster LT1-SC clutch, flex fuel, 12 psi [email protected] 1,800 D.A
2007 TBSS-Self tune, bolt ons [email protected], 1,900 D.A
1991 GMC Syclone- Self tune/catback 12.8@104, 4,200ft D.A
I was like 'no way dude, that's nuts!', grabbed the laptop and went down to my E40 truck because I was going to PROVE YOU WRONG and, well shit, there it is in special functions.Originally Posted by STAGEUP
Reply With Quote