I have a 2013 Camaro with a 5.3 LM7 drive by wire installed in place of the V6 with a 4 speed Richmond super t10 Manual transmission. I am attempting to hook up cruise control. I have all inputs and switches wired properly and have verified function with a scan tool. I have hp tuners and programmed the pcm with the manual transmission drop down selected. I have my speed signal, cruise on off switch, accel resume, coast set, tcc/cruise cancel, clutch switch added pin to terminal 35 of my blue pcm connector, and brake light switches all correctly functioning. My question is what am I missing? The cruise control inhibit command shows on but does not give a reason. I have no codes set. I have looked at many other people's situations with swaps but none seem to have a similar problem. Any help is appreciated before I decide to rip this crap out!