-
Tuner in Training
Subaru 2008 wrx
Hi just purchased a mpvi2 to tune my car and new to tuning.
Got it conected to the vehicle and pcm but now it has a error msg.
Definition fail to load. You will be unable to edit the file. Please email this file to [email protected] with a VCM suite info log.
Thanks in advance.
Last edited by Alstg180; 10-13-2021 at 10:49 PM.
-
Tuner in Training
Help please
Need help with pcm. the vehicle is a 2007 subaru wrx G3 when pluged in and have to enter the vin it comes up as a 2008 wrx but wont read the file. emailed HP TUNERS and was advised the vehicle has to be put back to factory.
I found a second hand factory pcm the same and tried it and still wont read keep getting error msg.
would it be possible to write a later model vehicle file to this std pcm?
I don't want to over write the tuned pcm as it a good tune file in the vehicle.
(HARDWARE SH_7058, Subaru) FAILED
OPERATING SYSTEM = AZ1E400C
CONTROLER UNLOCKED.x36 Exceed Number Of Attempts
Protocol Info: ISO 15765-2, J1962: CAN, 500 kb/s
ECM: 7E8, CAN
VIN:
Calibration IDs: AZ1E400C
Calibration VNs: 399C6DE3
Basic PIDs: 43
Trouble Codes:
Scanning Methods: ISO 15031-5 Mode 0x01 Functional, ISO 15031-5 Mode 0x01 Physical, CAN Listener
Don't want to waste 4 credits.
cheers Al
Last edited by Alstg180; 10-29-2021 at 05:45 PM.
Reason: image
-
Tuner
HP tuners does not like to read and flash an ecu if it has an existing cobb tune loaded on it.
2000 Camaro SS 408 TH400
2012 Subaru WRX STI
2013 Camaro SS
2001 Corvette Z06