Just swapped a 4.8 into my s10 and getting a code for no Input speed signal. The way I've read is the 07 and up 4l60e transmissions had that sensor. Do I just disable the MIL code in the setting?. The ecm and harness is out of a 03 6.0 4l60. The engine I have is an 07, but I'm not using that ECM.
Just checked the original ECM. Was a 2004 engine. Do I just need to use that ECM instead? I have 6 different ECMs laying around. I would just rather not spend the credits when I already have that one set up for the s10
Why not plug in the '04 PCM, do a read, and then compare the '04 file's DTC settings with the current file? Then just make them the same?
Everything is exactly the same but this part of the tune, where there is a difference in the ecmsOriginally Posted by blindsquirrel
4.8 ecm
4.8 trans tune.png
6.0 ecm
6.0 trans tune.png
So that means you have P0716/P0717 set to No Error Reported and still getting a code for ISS?
Reply With Quote