Someone with experience can help me or give a reference on how to adjust the startup and that the idle is stable after starting the engine with a 6.0 224/244 112 cam and worked heads, the problem is that after the idle is turned on it oscillates a lot until the idle target is found
Fueling/airflow are probably off
Email Tunes, [email protected]
96 TA Blown/Stroked, 4L80E/Fab 9
15 C7 A8 H/C 2.3 Blower/PI
14 Gen 5 Viper
Custom Mid Engine chassis, AKA GalBen C
Torque Follower needing bumped up?
Nope… that’s just for airflow after throttle movement from your right foot
Email Tunes, [email protected]
96 TA Blown/Stroked, 4L80E/Fab 9
15 C7 A8 H/C 2.3 Blower/PI
14 Gen 5 Viper
Custom Mid Engine chassis, AKA GalBen C
Custom Tune.hptCustom Tune.hpt Apparently there are problems uploading files I could barely upload my tune when I can send the log too, I did not make a good correction in the sd or maf, the headers are free with straight pipes approximately 20 in and I do not trust the reading of the O2, I would have done it directly with the wideband but I did not have much time I will continue correcting later
Reply With Quote