Good morning folks, I did a bunch of research the past couple days before registering to post so I apologize if I missed something. I purchased a tune via lund back in august. no issues other than needing to do a crank relearn with VCM scanner which was successful, it has you follow prompts and raise engine rpms etc..
Fast forward to now. I had a new mcleod twin disk, flywheel, throw out bearing and kooks long tubes installed. DTC in screenshot wants a crank relearn but everytime I go to do it, it just says "crank relearn successful" without prompting me to do anything like rev to certain RPM.
2017 Mustang GT
Things I have tried
-multiple crank relearns
-KAM reset
-battery disconnect for 30+min
-reflash lund tune
Reply With Quote