2008 sierra need help after cam swap (TRUCK NORRIS) thanks in advance !!!

[riko]

hello like the title states i did a cam swap on my 2008 gmc sierra here are the cam specs and mods i did

BTR GEN III & IV LS TRUCK NORRIS CAM

Specs: 212/22X, .552/.552, 107 LSA
also did long tube headers and a cold air intake
i plan on getting a bigger stall but that would be in a couple of months

id really appreciate if someone could point me in the right direction, the only thing ive done so far is disable the DOD,
started it up for a quick 20 seconds just to make sure i was getting power and all that good stuff but figured id ask for any advice or info
on what else needs to be changed or messed around with , im new to this tuning stuff and like i said i would really appreciate if someone could help me out so i dont mess something up ... not looking for a radical tune or something like that just keeping it safe and mostly doing this for the exhaust chop lol

thanks in advance

[Ben Charles]

I do remote tuning if I could be of assistance

[speedjunction]

Hello

You need to make a scan file with the vcm
scanner.
And let it run for a few minutes at idle.

No one will be able to help you here without information.

[riko]

ok thanks i will do that later i really appreciate the response

[dfost33]

can you PM me i have a buddy that just put the same cam on his 2007