Can't see Trans Tables after Reading Car

[haidar]

I have a Ford Explorer 3.5 NA engine 2013.
I am trying to adjust my shifting times 1-2 and 2-3 on the transmission. I want to make it to shift a little bit earlier.

On the VCM Editor, I do not see the complete shifting timing, Shifting properties and other tables to adjust timing of the shifting.
On the Trans I see:

Shifting Properties tab with 1 table called Boost time. On the torque converter I see some values but not tables like: General, Min Slip Upshift and Downshift. and Under the torque management I see one value which is Torque ;limit.

I am not sure if its supported for this certain vehicle.

On the VCM scanner I can see a lot of tables that are supported.
I tried the Basic and Advanced tab same thing.


Anyone can advise ?
Attached the VCM editing file please take a look.

[blindsquirrel]

There is a 2013 Explorer in the repository you can compare with, looks to me like the same tables as in your file.

[haidar]

so that means I cant tune my transmission tables? thats disappointed as I bought this inly fir this reason at the moment?

[blindsquirrel]

No idea. Ask in the Ford section (as this is a Ford issue, not an Editor issue) and/or open a support ticket.