Results 1 to 6 of 6

Thread: HELP!! Computer crashed during TCM Write and now wont read TCM

  1. #1
    Tuner in Training
    Join Date
    Oct 2019
    Posts
    14

    HELP!! Computer crashed during TCM Write and now wont read TCM

    My laptop crashed during TCM write in the editor and now HP Tuners will not write or read TCM, Is TCM done? Do I have any options? When try to Write I get message Unlicensed vehicle even though it is.
    Last edited by Garret99; 12-29-2021 at 03:06 PM.

  2. #2
    Senior Tuner TheMechanic's Avatar
    Join Date
    Jan 2014
    Location
    SoCal
    Posts
    1,558
    Possibly it could be perma-toast. At the least you will need a factory dodge programming tool to do a complete write.

  3. #3
    Banned
    Join Date
    Jan 2018
    Location
    Everywhere
    Posts
    1,772
    This is what scares me with HP Tuners, I?ve had too many bricked ECM?s from it

  4. #4
    Tuner in Training
    Join Date
    Oct 2019
    Posts
    14
    Seems that way, only thing i can think of is to somehow write the vin to tcm so it can recognize it, my autel scanner has the ability but of course says it?s not supported on the tcm module.

  5. #5
    Banned
    Join Date
    Jan 2018
    Location
    Everywhere
    Posts
    1,772
    You?d need to do a bench flash, it?s stuck in a boot loader for writing most likely.

  6. #6
    Tuner in Training
    Join Date
    Aug 2020
    Posts
    49
    This happened to me on my Audi, and it flashed NP after. Did you try to flash the stock unmodified file again?