ford change injector need help

[teamjin]

change bigger injector
what should i change in HPT editor?
do i have to change in red square line only?
inj.png

[pettis_adam]

No you will need to change all the injector data. Do this according to the injector data that was given with the injectors. There are some of the common injectors listed in a sicky.

[teamjin]

thanks.
but i knew flow rate@ pressure only.
Do i have to change is all? flow rate , pulse width ,Limits ,Rail temp , Offset , Injection timing , reference angle?

[Thatwhite5.0]

inj.png


What kind of injectors do you have?

[teamjin]

stock = BR3E-F5A
bigger = AF49-1900

[decipha]

Those are GM LS9 injectors unlikely you'll find ford data for them.

Best bet is to dial it in with the stock injectors then swap them and just dial the injectors in.

I would expect the high slope should calculate out to be just under 52 lbs/hr. ~51.72 or so.

[teamjin]

thanks a lot ..
can u tell me low slop ?

[mlecy]

If you can't find the data for them you can send them to Calibrated Success tell him what pressure you are going to run them at. He will run them on his machine and get you all that data.