So I have been doing SD EQ ERR to dial in the VE tables. I have the AEM UEGO wideband sensor installed just above the stock narrow band on the bank1 sensor 1 side. I dialed in the VE tables over a couple weeks now, and they're pretty spot on. I decided to enable close loop to see how everything was running between the wideband and narrowband sensors. My LTFT bank 1 jumps straight to 29% lean, while my AEM reads rich (around .79). Everything on the bank 2 side reads closer to 0 (under 5%) at .73 lambda. I don't know if i have something setup incorrectly on the editor, or if I'm having an issue with O2's. Resistance on all O2s are good. B1S1 O2 will start off reading around 450mV and then drop off to under 3mV while LTFT B1 jumps to 29%. B2S1 will read around the 450mV mark while LTFT B2 stays +/-5. I haven't found a vacuum leak, haven't seen anything wrong with injectors, and increased desired fuel pressure by 20% (just to make sure there isn't a fueling issue). I haven't experienced any knock, misfire, performance issue with O2s turned off. Any help would greatly be appreciated22-01-07 16-09-30.hpl22-01-07 16-53-54.hpl22-01-08 20-41-56.hpl