I'm using a Dynapack DAQ54 with their optional CAN module. It has the capability to transmit real time measured dyno parameters such as axle power and torque over the OBDII CAN bus and I would like to try and set it up so it can be read and logged by the VCM scanner.
This would be immensely useful when it comes to flash tuning complex matrix's such as dual VVT parameters as all the data would be logged by the scanner.

Has anyone attempted this before or does anyone have any info on how I can configure the Dynapack CAN output so it can be "read" as an external device by the MPVI2 on the vehicle's OBDII CAN bus (eg in similar fashion to the AEM 30-0334 OBDII wideband)?

The Dynapack CAN module supports 11-bit (CAN 2.0A) and 29-bit (CAN 2.0B Active) and all standard bit rates. These are the parameters I have to work with on the Dynapack side

Dynapack CAN output.PNG

Any info that could help me set this up would be greatly appreciated