Looking for info on the Can Bus

[stan65]

Received the Dakota Digital BIM-01-2 module today. I plugged it in, and it did not power up.

Figured out power, it is on the plug that passes data to the gauges.

It has 4 wires that go to the ALDL port. I rung them out and they are as follows....

Pin 2 SAE J1850 Bus+
Pin 10 SAE J1850 Bus-
Pin 6 ISO16765-4 (CAN Bus High)
Pin 14 ISO15765-4 (CAN Bus Low)

I have suspicion the harness from Dakota Digital is pinned incorrectly?
It is pinned correctly, see my comment above

The BIM Module is wired to power off Pins 2 and 10. My ALDL connector does not have Pins 2 or 10 wired. Neither does the ALDL port in my 2000 LM7 Silverado? once again I was wrong in my assumption

Anyone know the voltage or any other information on pins 2 and 10?
no longer need

I was unable to power up the module in my 2014 Sierra or the wife's 2016 Terrain either?
Its now powered up, the bad news it does not poll for data

[stan65]

So now I am on a quest for a device I can add to the CAN Bus that will initiate communications.

Anyone?