2013 Dodge Challenger, 5.7 NAG1. I recently replaced my valve body. The builder ended up sending me the tune for a different vehicle. My bad for not verifing VIN. Now the TCM module ID for that vehicle is loaded in my interface module and cannot seem to overwrite it or change it to my vehicle. Tuner has not been any help and HP is not a whole lot better for support. I have searched the HP support pages with little to no success.
Any on here able to help
There's a guy who post in the "engine" part of the Dodge section N2speed he might be able to help you , I know I don't have a clue as to how to help.
62 Biscayne 425/409 SS/D stock class car 10.60s
66 Dart 426CIG3 8.60@171 2750lbs Naturally asperated
04 Ram All Alum , 468Ci G3 10.50s @4800 lbs Naturally asperated
04 Rumble Bee, built 6.1 ,4000lbs 10.48 @ 129s MPH. Naturally asperated
05 Rumble Stock 5.7, 3.92s TUNE ONLY 13.94@98mph
Are you talking about the TCM OS ?
If you have not tried this yet, find your stock tune or last known tune with the correct IDs and write entire to the PCM instead of write calibration. Select write calibration on TCM. I ran into an issue a while back where the OS was changed and i just wrote entire back using my stock file and it fix the dead PCM
Reply With Quote