i need help with this tune it is stock but has no power and no get up and go it is slow and dont pull very good
i need help with this tune it is stock but has no power and no get up and go it is slow and dont pull very good
yes it is stock all but msd coils and cold air intake and 3 in exhaust and no cats
Got any check engine codes?
What about a datalog?
i do have a log and the only check engine code is for rear o2 and evp pump
Roger, if this truck is stock why did you apply the 2 BAR OS to this computer?
Do not use the 2 BAR OS if you never plan to run boost. The tune now has 2 BAR map sensor data in it and the VE table is now completely wrong because the table is now double in size but running a 1 BAR VE table in it. You can't run a truck with 1 bar MAP on 2 bar MAP sensor settings.
Go back to the stock file with a write entire and start over.
Once you do that you can alter the PE settings some. Change the hot/cold pedal enbable to 65%. Lower the enable torque to 50%, lower the rpm delay to 1,500rpm and set the time delay to zero seconds.
2016 Silverado CCSB 5.3/6L80e, not as slow but still heavy.
If you don't post your tune and logs when you have questions you aren't helping yourself.