Activity Stream

I found a 3.something download I will do once I get to work on another PC.

Depends on what year/model. The LT4 low side was upgraded in 2019 when the ZR1 came out. The ZR1 and Z06 got the better low side. It eventually made...

That would be the most recent/current version.

You can also plug a hole like that with lead shot. Chamfer the front & back of the hole, place a chunk of lead in the hole and squeeze with smooth...

I am using 5.0.4

Found in older versions of the editor.

Thanks all. I ended up contacting and getting a tune from PCM of North Carolina.

ive had to fix a hole in the blade before, i just took the blade out and got it welded then back in and tune properly, if u do that when refitting it...

ahh, ok, I set the DTC's correctly to NO ERROR REORTED.....but where it eh Post o2 test and cat test enabled found?

Email Support

You have to change a DTC to 'No Error Reported' to turn it off and all the associated tests the DTC runs and the actions taken depending on the...

ok, car is running much better, stock timing added back to it and VE adjusted. Now to fine tune it. However, the FUEL SYSTEM #1 CL FAULT seems to...

This is a fairly serious issue as we are finding logging to a computer thru a 6 foot usb cable is very unreliable. Windows keeps reporting device...

Yeah mate, he has done many LSAs both auto and manual with this cam and reckons it's the best cam for the GTS. I found him through his youtube vids,...

This thread is for Fords. Might have better luck over in the Chevy section.

I hear there's lots of info on Wikipedia, you could check there. Why does this need anything at all remotely special? This shouldn't be anything...

What did Stathi say about the cam, good to go for a manual?

that controller for the 4.0 is 1000 USD here at .64 conversion, 1500 AUD same damn thing is what it is... i would put a big block wedge...

dont just say this IS what it is doing... show us: lay the crankshaft rpm over the input shaft rpm (turbine speed) over the driveshaft...

more contempt prior to investigation. apparently its contagious...

i can help you with a base map though. just give me all the info you can.

auto or manual trans, it needs to be a trans supported by e38. otherwise its going to be a bad time tuning as it needs trans info to the ecm for tq...

I would also turn off your long term fuel trims and fix the MAF scaling and fueling since it's varying by almost 10% between LTFT and STFT, fix the...

at a minimum your torque tables and driver demand torque are off, I saw a little bit of throttle angle errors but not much, mainly it's being in...

It is the max RPM that VE corrections will learn at.

Got it figured out. ended up re-checking all grounds on the truck and found a few just barely hanging on by a couple strands. Cleaned all grounds and...