Activity Stream

You choose 43psi yet injector data starts at 50. All of them should run on at least 58 psi aka 4 bar. You run a stock MAF as your tune seems to...

Its the chassis issue, reads fine on a bench. Some of them read only virtual like 21-23 F150 used to.

Small chance that your pcm could be failing. But the more likely issue here will be either a wire, pin, or connection issue at your 8-wire...

vve tables viable for edit... manifold closed, open, dod manifold open, dod manifold closed, intake angles from-20to+20(/1deg) ... 4*41=164 tables to...

Sounds good You won't need the Volumetric Efficency... Your VVE is base on MAP and RPM.. The 2014 Silverado tune I looked at was P-Ratio and...

did you find ? i am looking for one to compare with my magnuson supercharged file

@gtstory - thanks for the reply, I will keep that in mind but I'd hate to have to redesign everything. Its a 2004 wrangler 2dr Rubicon. The SKIM...

Did you find a solution?

Did you find a solution for that?

If you're running in closed loop, adjusting the stoich value will only have the net effect of skewing the fuel trims in the opposite direction of...

thanks ill add those channels and do another log with them. no wideband yet

You will need to add these channels Add Channels to your log: -Mass Airflow HZ -Knock Retard -Cylinder Airmass -Dynamic Air Flow -Baro -Intake...

hello all, my name is Shelby, and I have a 98 Mustang that i coyote swapped about 5 years ago. it's a stock gen 2 backed by a built 4R70W manual VB...

According to the log. P0135 - O2 Heater Circuit (Bank 1, Sensor 1) (Current) P0141 - O2 Heater Circuit (Bank 1, Sensor 2) (Current) P0155 - O2...

Add Channels to your log: -Mass Airflow HZ -Knock Retard -Cylinder Airmass -Dynamic Air Flow Assuming you don't have a wideband? Can you...

the tune

It could be, they are 4 wheel disc. So enable the brake torque management, and keep the torque limit maxed? That log didnt have an attempt at a...

finally able to upload logs to first post

I've been wondering for some time now, how was this tune able to run so much timing without knock? This was a log of the tune previously in the...

I'm finally back with the latest on this car. I think I'm close to finished with it. The log isn't the best, but I did get one WOT. The turbo does...

Look at ECM 289 setting. Change it to Enable and try again. I didnt see any attempt at a burnout in the datalog. Its possible your rear brakes...

assuming the clearances are correct for the type of clutch material & hp you're going to put through it, the easiest option is to swap the valve body...

Hi there, did you get your NAG 1 performing like you wanted ? What Valvebody did you use ? Hows the 3-4 shift ? Cheers Garry

How about this one? RR3A-SEMWS2-BCE