Activity Stream

Here's a stock file. Thanks for the response and willingness to look!

I think it's as simple as disabling lockup in gears 1-3 by setting the engage speed to max. I also disabled the torque management and removed...

On the innovate widebands you can program what you want the voltage output to be during warm up when they are not giving an actual reading. Using a...

please post your stock file as well

how about posting some data logs? did you actually adjust the VE tables at all?

Here is the asfound as requested.

The preset hpt wideband options are not 100% perfect. I noticed on at least 2 they skimped on the rounding and my math was a good amount different....

Correct I still do want the vvt advance function in lower rpm?s and retard in the upper rpm?s. Just adjusting drivability stuff.

I have to say i have been using trims for tuning along with a wideband for pe. I am needing a lot less revisions to get a tune dialed in. Cant...

No it?s stock cam and phaser setup. Just taking the cam phasing ?retard? movement out of the lower areas and this is done and based off a reputable...

Need to tell the tooner what brand/size of TB. Intake manifold will definitely need a VVE correction. As far as the yootoob tooners, be sure to...

From my standpoint and experience, yeah. Like I said, there have been a few people claiming to tune around it, but I haven't found the silver bullet...

That?s why the limiter gets put in so it can?t move. But I don?t think that?s what you?re trying to do. It sounds like you want it turned down in a...

What you mean by a limiter? Nothing else changed with vvt but tables I previously posted. Put these tables back to stock settings everything ready?s...

Did you put a limiter in it?

Which codes would need to be changed to ready in this situation? You wouldn’t think any with stock setup still. But must be something. Thanks

Change ?desired angle? and ?VCT? spark min monitor won?t ready.Confused. VVT cam phaser is still there just taking the retard out it.

Nope still won’t ready when tables are zeroed out to take the cam retard out on cruise range. Been a week now won’t ready lol. Turn can retard back...

Leave the ses enable checked. It should do the test but not see any codes if they are set to no error reported.

Got quick question here for the knowledgeable? What about if you need the monitor to ready for inspection on egr vvt? All the above info will not...

There's more to it than just adding fuel. There's timing and boost control for starters. That tune isn't terrible, but there are some weird things...

Go in Fuel system- fuel pump- change off duty cycle from 75% to 50% that should run your fuel pump constantly.

When i was referring to look into your map sensor i was actually saying to look into the actual functioning of it. Like is it is range or does it...

This will fix the incorrect Trans Revs/mile. The calculated tire dia was 24.99". Looks like your throttle is only opening to 71-78% most of the time,...

You couldn't have popped up at a better time. I was just looking back at this post, hoping that someone had added some info here as I'm just now...

I updated the VE tables. They look alot better, just took me a minute to understand it all and how it changed. That does not mean i did it correctly...