Activity Stream

although I am feeling really happy with where I am at....I still think my throttle response when I blip it off idle could be better...but that might...

hi @Sweet35th what is the status now? • Will the MPVI2 (or MPVI3) interface support all PIDs, reflashing, and logging on my Edge’s PCM/TCM? i...

Fuel pump doesn't look like a problem either. They will fall a couple PSI.. much more than this it might can indicate a issue but you need to log...

This doesn't look lean at all. Fuel trims are averaging pretty close to zero. This is closer on fuel trims than most factory off the road cars. ...

You are correct. I thought it only worked with the RTD devices, but that was incorrect.

S650 reading should be working as of VCM Suite 5.1.4626. We've confirmed on three cars at this point, but you may need to retry multiple times before...

I took your tune and put into SD so you can tune the VE. Youre lean in most the areas youre getting knock, as was pointed out. I changed your...

For 24x, only 1x cam is currently supported. For 58x, both 1x and 4x cam work. It is always advised to use a timing light to ensure correct...

Yes From my limited expearience, its more for when you add a booster pump and how that "spike" in pressure/flow is dealt with. Might not be enough...

So to confirm if my new build is 58x trigger and 4x cam gears there is no need for the lingenfelter box correct? This ecu allows you to change to...

fix this

I think sirius had a 98 or 2000. Mine is a 2002 ws6 LS2 swapped, LS3 top end with a TSP F35 cam kit in it and a 6sp. Just got done doing UMI...

If you send me your file I can help you out

This sounds like a stock PCM, if you purchased the crate engine setup from GM there should be no limp mode. Depending on the calibration make sure...

Very possible as there were only ~1,000-1,500 made according to the internet. Part number is 4014453. Says on there that it is programmed for a rzr...

can you mix/match the crank and cam? 24x/1x - 24x/4x - 58x/4x - 58x/1x

No problem. I think you're correct

Cool, thanks for the feedback. The reads and writes do need a good connection to the internet indeed. I believe reads are essentially virtual reads...

RDF1 is right, CORE supports both 24x and 58x reluctor wheels. You just need to set the correct setting in the tune file.

Hi, can anyone here do an engine remap for my f-type r? (log attached)

ruthless racing tuned So far, it seems like I'm the only one going 90mph on 325 and 300

Yes, MPVI3 works with TDN and tuners can sent the tunes via TDN and load it to ur vehicle from ur cellphone. This tune only works via TDN cant work...

He's had decapped injectors, then some Bosche's that the supplier has (maybe) been uncertain on. Plus, maybe another set that didn't behave.

id assume so..there is a table to change commanded fuel pressure

what type of firebird? i own a 91 gta

I've been back and forth a few times with the HP Tuners support. They recommended I try a bench harness to try and read the tune off the ECU. I tried...

If you read the description for Brake Torque Management setting its kinda backwards from what you think. If you want to disable BTM when you turn...