Activity Stream

Dont you know it always the tuners fault? Had a car on my dyno that blew a tire at 160mph and took out his quarter panel, tuner fault..... LOL SMH....

P59 run L31 based 383 cold start. Biggest problem I ran into post swap was the transient tables that HP Tuners does not have defined in their...

i thought these were sketchy to read? i heard people bricking pcms just trying to read it??

HP Tuners licensed it just fine for me with the Mexican VIN. Might be a table you do not have access to given it was a manual transmission file to...

I just dealt with the facebook gurus recently from a video that got posted of a car spinning a main on my dyno. Tread lightly.

I did pull this one off and locktite the blade screws and install new sensors not long ago. Everything felt good as far as shaft play or blade...

I see. Thank you for the clarification on that! Ill start over...again :shrug: lol

Those junky aftermarket throttle bodies aren't a challenge to tune.. they are often not tunable because the blade doesn't come to the same stop, ...

That isn't correct. It's describing how the IAC passage flows vs steps.. Well its saying the hole is equivalent to x You shouldn't need to...

Error of where it is in steps vs where it needed to be. I was under the impression thats how you adjusted for a larger TB on DBC. Idle Desired...

stock 1998 Chevy 1500 5.7 Vac ref Tune is a 2005 Chevy Silverado 1500 5.7, vin is just an astro because hptuners wouldn't license a Mexico...

Here you go

Lets get one more good log like that and then we can tackle the MAF curve. Its nice and fat on the top end in most places once it hits PE and i...

sorry for not updating ... winter came, also I started working on a Gen 5. I am back to this now. Ive got 90% of the popping resolved by turning off...

AGREED, no good deed goes unpunished these days

here is a stock read of the 2024 renegade 1000, Had success flashing it with a tune.

I guess that's a no? lol

I'm guessing this response is because the original ask was ambiguous. A CM2100 has something like 2800 editable parameters (not all in the HPT...

Error percent of what? You shouldn't have to touch that table. It's causing your BRAF numbers to be unrealistic. Put it back to stock. Leave it alone.

Thanks Rob!!

So, comparing this revision to the E85 Tune05282025, what is so different that it works and not the other one?

It's coming down to 9 volts trying to start. This is likely at least part of the problem.

Couple logs of trying to start it

Found this on the support website. VCM Scanner Help > Channels > Adding Channels > Devices That Connect to a Serial Port Devices That Connect...

Your MVPI device doesn't have the green 8 pin connector on the side?

The Main VE table goes to 210. The start up VE only has up to 105. It didn't change with the file conversion and I couldn't find any info on if this...

I am sorry, I dont know what A/D input 1 is. I don't think I have that.

BRAF numbers that have been changed from stock number came straight from the logs i posted. Hasnt been colder than 70F so i havent gotten much cold...