Activity Stream

I agree with RobZL1 and with the tools from Cringer for MAF & VVE, it's a relatively quick process :) 1) I found the easiest way to adjust the...

if you by any chance replaced the exhaust manifold gasket with anything other then the factory it can do that. been there went through it i triple...

It needs tuned, your AFRs are all over the place. If its a street vehicle turn the fuel trims back on, this usually significantly helps part throttle...

Thanks!

Appreciate cha!

I posted that stock read in the ecoboost section if you are wanting to look at it prior to doing anything with that F-150 to see the controller info...

I will be testing that soon enough with my '21 F150 2.7 eco. I am hesitant to buy credits due to this not working for Mustang folks, but if you...

He was perma-banned from here over "the incident", and I have never seen that username on any other forums.

Just pulled a file off my bronco, I know not a mustang, but does have the MG1 computer as well and they just dropped support for it today. I saw 2...

The one thing that stands out for me, is the PCS 2 pressure pulsations (in yellow). It only does this after engine start and initial acceleration.

so no one has any thoughts about the tune or data logs?

isn't SD better to tune the fuel map? from what I've been learning SD is easiest way to start getting things dialed in along with timing idle air and...

Do hou mind sharing a copy of that file? Please! Im about to do this exact swap and It would be helpful to have it.. TIA! [email protected]

Take it for a drive and see how it does. Were you fiddling with the throttle on that cold start?

I especially hate that most of my property tax is school tax, since I never had kids. I understand the whole "civic duty to educate the future"...

Seems like they're having issues with the MPVI3, I've been back and forth with them all day updating the software and trying over and over, it gets...

Have been talking to techs... 5.1.4620 made a little more progress reading, but then boinked again after on/off request... Hopefully the fixes will...

Yea that property tax crap is robbery. If you pay in full for it, you should not have to pay anything else for it. Insane that something has not been...

Quick update from my commute home... Now I'm getting P2135 codes again. This is an electrical gremlin from hell. At 26m39s in this log, the truck...

I would be surprised if the flow rate changes much with temp. It seems like once you get to things with the viscosity of water or less then the...

I updated the MAF to reduce the flow by 10% and the LTFT came down. I also increased the timing. Runs alot better. Still bogs a little on take off...

anyone heard from Sirius?

Hmmm. not sure why not. https://youtu.be/CrGYxGgJm5w

I will test that tomorrow, row by row. Here is a "cold start" log from today.. but it's like 85 degrees out. :cool: Still longer cranking than...

Whats your ticket number? Keep in mind MPVI3 pro feature set is a no charge feature.

Set P/N rows to 0 and see what happens. Or select gear in the channels and see what it defaults too.

What are you trying to accomplish by setting your stoich to .0730? I haven't looked at your logs, and won't be able to for a bit. But, ultimately,...