Activity Stream - HP Tuners Bulletin Board

Sort By	Time	Show
Recent Recent Popular Popular	Anytime Anytime Last 7 Days Last 7 Days Last 30 Days Last 30 Days	All All Photos Photos Forum Forums

15 Minutes Ago

Tybuch16 replied to a thread 17 cummins tow tune in Dodge Tuning - Engine, Diesel

Hey jim, I?ve read lots of your threads or threads you?ve been on I believe you can help me. I have a 2014 6.7 Cummins cm2350 I need some help with....

2 replies | 196 view(s)

27 Minutes Ago

Bill@HPTuners replied to a thread Segment swap for timing under boost. Possible? in GM V8 Tuning - Engine, Gas (Gen 3)

No there is not.

1 replies | 0 view(s)

27 Minutes Ago

KFXGUY started a thread Segment swap for timing under boost. Possible? in GM V8 Tuning - Engine, Gas (Gen 3)

I have a p59 ecm, 2004 GTO. Is there a way to segment swap a boost timing table into my OS? I'm really sick and tired of using a scaled tune. Its not...

1 replies | 0 view(s)

48 Minutes Ago

edcmat-l1 replied to a thread Blowing through converter?? in GM V8 Tuning - Engine, Gas (Gen 3)

Blowing through a converter happens almost always from a holeshot. That's when it's under the most load. A 600 hp engine isn't blowing through a...

5 replies | 38 view(s)

49 Minutes Ago

RDF1 replied to a thread Parameters help from tunerpro to editor in VCM Editor

Please explain

1 replies | 3 view(s)

53 Minutes Ago

Tadej started a thread Parameters help from tunerpro to editor in VCM Editor

Cant figure this out getting parameters from tuner pro to vcm editor beta

1 replies | 3 view(s)

1 Hour Ago

dave011182 replied to a thread 2016 Sierra Tuning, coming from a Diablo i3 in GM V8 Tuning - Engine, Gas (Gen 5)

Thanks, that sounds like a good workaround for being able to swap tunes without having to carry laptop around after you've already made the tunes you...

2 replies | 30 view(s)

1 Hour Ago

RDF1 replied to a thread Blowing through converter?? in GM V8 Tuning - Engine, Gas (Gen 3)

I would rather run a taller tire or higher rear gear to keep it in 3rd gear and a better TC to be able to lock it up in the top of 3rd at around...

5 replies | 38 view(s)

1 Hour Ago

DodgeBoy_8HP replied to a thread Nag1 with more stall torque convertor in Dodge Tuning - Transmission

Do you have a log where it surges?

1 replies | 41 view(s)

1 Hour Ago

DodgeBoy_8HP replied to a thread Possible flash stock TRX TCU to Trackhawk file in Dodge Tuning - Transmission

Not possible with HP Tuner... I would assume you need to change the VIN number I believe you will need to send it to the guy....

1 replies | 28 view(s)

1 Hour Ago

anniversaryss replied to a thread Blowing through converter?? in GM V8 Tuning - Engine, Gas (Gen 3)

Thank you. Yes I've planned on contacting the converter company. How can you tell from my log I am not blowing through it? It doesnt feel like I...

5 replies | 38 view(s)

1 Hour Ago

edcmat-l1 replied to a thread Blowing through converter?? in GM V8 Tuning - Engine, Gas (Gen 3)

You're not blowing through the converter. The people telling you that don't know what it means. If you want to lock it in high gear call the...

5 replies | 38 view(s)

1 Hour Ago

Alex14SS replied to a thread 2.0T FSI EA113 BPY K03 Tuning in Audi/VW

People here are going to help you on any technical help not give free tunes. I’d suggest learning EFI and how euro engine operate so you could figure...

2 replies | 113 view(s)

1 Hour Ago

bk2life replied to a thread Blowing through converter?? in GM V8 Tuning - Engine, Gas (Gen 3)

add all the trans slip channels and log it. Id delete everything else so youre only seeing engine rpm and then everything the trans does to not...

5 replies | 38 view(s)

1 Hour Ago

Alex14SS replied to a thread G37 no read in Nissan/Infiniti

yeah I got UpRev and it worked. HPTuners probably abandoned Nissan Infiniti support. Only works for RWD cars too which they don’t specify at all...

3 replies | 3395 view(s)

1 Hour Ago

Alex14SS replied to a thread 2016 Sierra Tuning, coming from a Diablo i3 in GM V8 Tuning - Engine, Gas (Gen 5)

The best way I’ve been able to do that was reading it on the app then flashing a different file and reading again on the app and it would work for...

2 replies | 30 view(s)

1 Hour Ago

anniversaryss started a thread Blowing through converter?? in GM V8 Tuning - Engine, Gas (Gen 3)

1997 LT1, heads/cam, 4l80e w/3800 stall speed, dana 60 rear with 3.73 on a 25.7(stock size) tire, Procharger with 14.5psi and e85. Converter is a...

5 replies | 38 view(s)

1 Hour Ago

edcmat-l1 replied to a thread 2004 chevy corvette in GM V8 Tuning - Engine, Gas (Gen 5)

Post over in the GEN 3 section. Being bored .020 over isn't going to change much as far as the tune is concerned. And if you're talking about the...

2 replies | 26 view(s)

1 Hour Ago

edcmat-l1 replied to a thread 1998 c5 brick issue after 3bar swap? in GM V8 Tuning - Engine, Gas (Gen 3)

You're logging way too many pids for the PCM. I'd get rid of all of them except RPM, MAP, MAF, timing and injector pulse. It's not reading any RPM...

9 replies | 176 view(s)

2 Hours Ago

gtstorey replied to a thread 2004 chevy corvette in GM V8 Tuning - Engine, Gas (Gen 5)

Not a Gen5 for this forum.

2 replies | 26 view(s)

2 Hours Ago

w313zrd replied to a thread cannels and charts for newbie diags? in GM V8 Tuning - Engine, Gas (Gen 5)

thanks, here is a log... went out earlier so the truck was ideal for showcasing my issue, with idle.. . any insights will help. and greatly...

2 replies | 104 view(s)

2 Hours Ago

LouD started a thread Help Dissabling Automatic Transmission Features in Ford EEC-V Tuning

Has anyone experienced issues with HPTuners not dissabling the automatic transmission features even though all the transmission features are checked...

0 replies | 26 view(s)

3 Hours Ago

dave011182 started a thread 2016 Sierra Tuning, coming from a Diablo i3 in GM V8 Tuning - Engine, Gas (Gen 5)

I'm looking to replace my current i3 tuner for more control and expandability on what I can do. I've played with the TDN app, and VCM scanner using...

2 replies | 30 view(s)

3 Hours Ago

2pacjoey started a thread 2004 chevy corvette in GM V8 Tuning - Engine, Gas (Gen 5)

i am looking for a base map tunin file with 5.7 .20 bored over and that has a vacuum pump delete on the file thank you!

2 replies | 26 view(s)

3 Hours Ago

2pacjoey replied to a thread 2015 chevrolet silverado in GM V8 Tuning - Engine, Gas (Gen 5)

thanks man , thanks for your help again ahaha your houston too that dope what part ?

2 replies | 84 view(s)

3 Hours Ago

bk2life replied to a thread C10 6.0 T56 newbie in GM V8 Tuning - Engine, Gas (Gen 3)

about 5 to 10 miles is all you really need at operating temp and have your passnger watch the scanner and you try to fill as many blocks as...

5 replies | 87 view(s)

4 Hours Ago

JASON11WS6 replied to a thread 1998 c5 brick issue after 3bar swap? in GM V8 Tuning - Engine, Gas (Gen 3)

Here is the scan on the attempted start up. Not much is reading.

9 replies | 176 view(s)

4 Hours Ago

bk2life replied to a thread gen 3 5.3l cam idle and ve table tunning in GM V8 Tuning - Engine, Gas (Gen 3)

do you have o2 sensors in there? i dont see them being logged your commanded a/f seems off to what the w/b is reporting its pulling alot of air at...

1 replies | 39 view(s)

4 Hours Ago

Roman started a thread Dodge Ram 6.7 2024 in Dodge Tuning - Engine, Diesel

Hi I need emission flash for off-road purposes if some one can do pm me

0 replies | 25 view(s)

4 Hours Ago

JASON11WS6 started a thread Gen 2 coyote eq ratio commanded sitting to rich in Ford Tuning - Engine, Gas (Non Ecoboost, US)

New Coyote tuner here. Looking to tune this for boost but at idle the car keeps commanding more fuel. Sure I missed something in the tune. Also...

0 replies | 29 view(s)