Activity Stream

A direct answer to your question is Yes if the ground fell of in transit it could cause big voltage spikes and fry components... Can you...

try changing Target TR Sport to 0.01 across the table under the burble tab

Keep in mind two things: - Your stock compare file is a different OS (older 12605898 vs yours with 12614088) and - There are lots and lots and...

mstang_man Thank you very much that actually got me really close and after just a few changes throughout the table believe I got it whipped and much...

ok. I did some googling on forscan and bought it last night. It was not to bad. The license was like $12 and the ODB2 cable was about $60 on...

Post a Tune and a Log and you will get much better responses...

Defintely need to change some things first before you do any tuning. You are logging too much data in the scanner, only log what you need. Your long...

Awesome. Thank you. I will look into it all.

agreed. Some people LOVE to hear themselves talk that's for sure..lol.

That still helps, thank you.

For the fuel lobe I had under cam changes in the first post. But as GHuggins points out, it can be done much better in the way he shows. The Y...

shoot you a PM

Just found out the fans will turn on if I unplug the maf. The truck idles smooth but fans will not turn on but once I unplug the maf the fans kick...

Reading more on the Flex Fuel, I understand better that the wrangler OS did not have it enabled. I have put in a support request to see if a patch...

I'm guessing this tune has the best stumped? Maybe this PCM is garbage to?

Thank you...I'll go log some time on it now and post.

There are several areas for improvement on the tune. But it sounds like you need to check the coolant system first. Was it topped off with coolant?...

Stock

If the Gen 4 to Gen 3 Knock Sensor "adapter harness" that you purchased has 2 of the wires coming from the Gen 4 Knock Sensors, that then plug into...

try changing these tables just like the inset here Under torques Management ETC torque Management. see if this helps

And yes, very different to a dyno reading. Unless the dyno sheet is from an engine dyno.

All the same. Can't remember which one but one of the engine ones clips at 850Nm or thereabouts.

The engine torque tells the trans how much line pressure to apply. E.g. you're making 1050Nm on the dyno but engine torque PID shows only 500Nm, the...

https://forum.hptuners.com/showthread.php?58447-Dodge-PE Is a good thread to help you out. ...

Where the engine went "dead" appears to be DFCO. Lambda went to 2.0 and it was decelerating. The fuel source didn't switch immediately but I...

Niffty little tool you guys built, I have gone even less than 25% i have been pretty close with 10-15% factor. the good thing is you can dial this...

With forscan you can read and save each module in the vehicle, once you put the replacement in you have to reprogram it with the as built data, i...