Activity Stream

Use filtering. Say Knock > 0.0. Now it will only display values when that condition is met. You could display an average of these values or a count...

Thank you for checking. I have forced it into speed density with adders out of the picture and was hoping I could get it dialed in this way. I looked...

You got a lot going on here. Your BRAF is WAY TOO high. The idle trims are pulling half of the airflow out of it. You're in open loop and...

Amazing stuff, great job!

There is no VVE table in the Global B right? SO is this basically a global B motor with a 2014 ECM? I am no pro by any means but if its still using...

Ok here is the current tune installed in car with 2 datalogs of the oscillating and stall both are with engine warm in park. The tune is the last...

If the trims are adding a bunch, need to check the fuel pressure. That should be the first check to make regardless.

Compression and leakdown tests, followed by a visual inspection of the valve train. Pull the valve covers, pull all the spark plugs, crank the engine...

Transient fuel is too high. VE is numerically incorrect due to bogus injector data. Unless you plan on running a bunch of boost you're better off...

Here's a log file with a few additional parameters. I've tried disconnecting the MAF (I read a few other threads where that allowed the car to start...

bmpcamry09 and Volstang, I'm really curious if you would be willing to share more about cam angle suggestions for the GEN2 3.5 EBs. I used to get a...

Thank you Alvin. When i said i am looking for a tuner, i do net mean someone that can tell me how to solve a problem, but i need someone that can...

That curve looks solid to me. I also find it comforting that the quadratic to linear transition doesn't aggressively snap to high load values when...

I'm sure there is an easier solution than I had, but my 2007 P59 Express Van PCM was only happy with a 2007 Express Van TAC module and a 2007 Express...

At least a 150 ton should be a straight floor mount. I work with everything from 50T Niagaras to 1000T Verson. A couple of our 800T presses are...

I didn't buy a $400 dongle, so i don't get to save tunes for free remote tuning assistance to others.

Kinda like that "shoo, men are working" sounding snark earlier? But now more explanation is fine? This shit goes both ways.

when you log the VE correction which I am doing now what do you do with it then? I have the log and the numbers but not sure what to actually do with...

Alternatively, my suggestion many here criticize. Idle set screw on throttle body and disable all the idle adapt/compensate/error stuff. Then the...

Does rolling idle not do anything on a manual? I assume not. Have you tried smaller numbers in These tables? Halve the highlighted numbers, see...

Yeah it is. I should’ve fixed the header when it was out the first time, but that’s ok. It helps distract from PTSD and anxiety. Army DV. IT calms my...

my ballringer bounces back and forth between .995-1.035 lambda it does so regardless of where my trims are short term or long term its...

It's my pleasure. I like helping out.

I would rather have accuracy and repeatability. Not everyone tunes the same…even though it can be done either way, I’m on engine #2 because he wanted...

The MIL thing was hilarious.

I try to dial all of it in - it helps minimize fouling up the combustion chambers.