Activity Stream

I've dealt with similar SAI issues on Toyota trucks. If you're looking for a reliable solution, I recommend checking out some diagnostic tools or...

No but fuel trim resets just require disconnecting the battery for 10 min or so.

Make sure your pedal wiring matches the pinout I uploaded. HPT wouldn't let me attach it as a word doc for some reason.

Just pull the tune off of the ECM that you have and start there. You don't want to go flashing in other peoples tune unless you want some real...

Hi All, Shannon here. Reside out of Sydney, Australia. Been a member on here for many years but never posted, just always tried to search, read and...

Sydney, Australia.

If you could share that tune it would be greatly appreciated. I'm looking at starting my base tune soon to suit TSP Stage 2 in a 5.7L

Thnx Alvin, I totally agree that a proper dyno tuning with 2 bar stuff would be a killer move, but at this point I just need to lean out that fat...

My recomendation would be to make a few log all the necessay channels to calibrate your MAF with your o2 sensors. To me that is the easiest to adjust...

I agree wholeheartedly with all that about theft and the tuning world, I get it, spent years staring at numbers trying to figure it out. But this...

This is the stock read from a 1.6 USDM Fiesta ST

would you okay it to do the 25-30 minute drive directly to the tuner as is?

Id fix my IAT issue and do a little "self tuning" to clean up the fueling before i took it anywhere that far. COULD it make it that far? Probably so,...

No, the rear sensors are technically not required to keep the cats. Just have to set the codes correctly for them and it's really not an issue. ...

I over revved a stage 4 high ram build. Spun the bearing on purpose. 6500 rpm max on the log. Also had too much timing and too lean at 21* and .82ish...

Same with the trucks?

your input has been extremely valuable. I thank you very much. As to why i dont just tune it myself... time. I work for myself with no employees or a...

I just saw that. I'll look into it. Could have been I was cranking it for too long. I'll put a booster on it and see if that changes.

oops move this thread to gen 5 please

Startup wasnt logged in that file. Youre not showing knock anywhere. Also running pretty rich everywhere, better than lean if youre not tuned.......

does this show whats needed? i did note that it was hard to start when i went out just then, never done that before.