Activity Stream

dont just say this IS what it is doing... show us: lay the crankshaft rpm over the input shaft rpm (turbine speed) over the driveshaft...

more contempt prior to investigation. apparently its contagious...

i can help you with a base map though. just give me all the info you can.

auto or manual trans, it needs to be a trans supported by e38. otherwise its going to be a bad time tuning as it needs trans info to the ecm for tq...

I would also turn off your long term fuel trims and fix the MAF scaling and fueling since it's varying by almost 10% between LTFT and STFT, fix the...

at a minimum your torque tables and driver demand torque are off, I saw a little bit of throttle angle errors but not much, mainly it's being in...

It is the max RPM that VE corrections will learn at.

Got it figured out. ended up re-checking all grounds on the truck and found a few just barely hanging on by a couple strands. Cleaned all grounds and...

Here is the stock file I got from the repository.

Yes I will post the original when I get home. The original file was just a 6.0 manual file from the repository. It did the same exact thing with it...

Scan;

It's part of the Speed Density, it's not just the IC volume, but also takes into count the volume of the charge pipe or pipes if you dealing with a...

i also would like to know, it seems its a unitronic ecu.

I have not fallen of the earth by the way. I've had more important things taking up all my time, but I'll get back to the car eventually.

You mean me, or Omega?

The car runs like a scalded dog. The transmission is near brand new and there is nothing wrong with it. It shifts 6th gear just like the rest in 200...

Yes, I want to see them. geometry vibes

its not that recovery rpm is well above stall tire spin or clutch slip is it blowing the tire off at 100 mph?

I?m trying to contact you but I haven?t figured out how to. I really need your help

Here is one when the converter clutch appears to takes hold after a time and the rpms start to climb. I have used lockups in the past on other...

You can't be serious, what are you high on ? Just kidding. This trans shifts like a rock all the way through to 6th (without using the lockup after...

that is clutch slip steve - has nothing to do with the converter clutch pack in drum C is excessively worn, or the tune is wack. once trans is...

Thanks...that worked with some fiddling. I had to set my times to beyond the "end of lap", which is exactly 50.100 If I used 50.100, the lap time...

Any update on when the logging will be working on the MG1 ECUs

Thanks all for your reply, this sunday I've been tuning the car on a dynojet (inertia only,no eddy current brake), the final results was 781 Nm and...