Activity Stream

Yes From my limited expearience, its more for when you add a booster pump and how that "spike" in pressure/flow is dealt with. Might not be enough...

So to confirm if my new build is 58x trigger and 4x cam gears there is no need for the lingenfelter box correct? This ecu allows you to change to...

fix this

I think sirius had a 98 or 2000. Mine is a 2002 ws6 LS2 swapped, LS3 top end with a TSP F35 cam kit in it and a 6sp. Just got done doing UMI...

If you send me your file I can help you out

This sounds like a stock PCM, if you purchased the crate engine setup from GM there should be no limp mode. Depending on the calibration make sure...

Very possible as there were only ~1,000-1,500 made according to the internet. Part number is 4014453. Says on there that it is programmed for a rzr...

can you mix/match the crank and cam? 24x/1x - 24x/4x - 58x/4x - 58x/1x

No problem. I think you're correct

Cool, thanks for the feedback. The reads and writes do need a good connection to the internet indeed. I believe reads are essentially virtual reads...

RDF1 is right, CORE supports both 24x and 58x reluctor wheels. You just need to set the correct setting in the tune file.

Hi, can anyone here do an engine remap for my f-type r? (log attached)

ruthless racing tuned So far, it seems like I'm the only one going 90mph on 325 and 300

Yes, MPVI3 works with TDN and tuners can sent the tunes via TDN and load it to ur vehicle from ur cellphone. This tune only works via TDN cant work...

He's had decapped injectors, then some Bosche's that the supplier has (maybe) been uncertain on. Plus, maybe another set that didn't behave.

id assume so..there is a table to change commanded fuel pressure

what type of firebird? i own a 91 gta

I've been back and forth a few times with the HP Tuners support. They recommended I try a bench harness to try and read the tune off the ECU. I tried...

If you read the description for Brake Torque Management setting its kinda backwards from what you think. If you want to disable BTM when you turn...

hi, why dont you tell us a about your set up, goals, and what games you have been playing? We cant tell you anything without any input from you. ...

I updated firmware before I did the initial read. I think I figured it out. I was flashing on the road, via my phones Hotspot. I believe I am near...

Yep, confirmed my '21 Ecoboost reads and writes just fine. No hiccups so far with the Beta.

It is possible that HPtuners does not have a read from that particular ECU. What is the part number on the front of it? 401xxxx?

I assume you are talking about fields 3003 and 3033. If so, 4000 and 3900 RPM are the desired settings (which is OEM stock). Typically tuners will...

Well an update. Took trans out Saturday and found a leaking front Torque converter fluid seal. Output shaft seal was leaking too, but I didnt replace...

Try these. I would also suggest looking at your VVE airflow and Fuel Injector IPW valves when this happens.