Activity Stream

I haven?t touched the spark tables myself. They were done by the shop I bought the engine from when they put in the cam. They made the original tune...

I can re-enable closed loop because the sensors are still installed in the exhaust system. I like the idea of closed loop for part throttle...

I had a 2013 Fusion 2.0 that I used Cobb for tuning on, and I could set my shift tables up anyway I liked

Sounds like it thinks it's in park or neutral far as the rev limiter goes, the no start might be because it doesn't know if it's in park of neutral.

I reccomend especially for new tuners to disable the MAF, tune VVE then renable the MAF later if you wish. Being procharged. I'd do a 2 bar OS...

How was the spark timing tables derived?

This table is from a stock 392. Now I'm going to subtract 9 degrees to get the offset correct. This is for the WOT cam timing. Do the same...

Welcome! You'll want to familiarize yourself with tuning first, https://www.hpacademy.com/courses/efi-tuning/ Next you'll need a wideband sensor...

My goal is to reach 9.99 in the 1/4 Naturally Aspirated . I started bone stock with a 12.5 ET, 11.6 with CAI, tune and some weight removed w/drag...

This is a similar tune to the one i posted before and this one had no effect on anything as well. This is also the data log that i did with this...

Yes sir, Gen3 2019 10spd base model.

Has anyone run this harness? What all did they change in the setting?

wow, that's getting all of it! This is in a Gen3 S550 Mustang?

still on stock cams, best time in the 1/4 mile was 10.53 @ 129.8 Mods are long tube headers, JLT intake, E85 and weight reduction. Car made 460whp...

No cams on yours? Do you have track or dyno results before this upgrade?

I second that, HP Tuners is user friendly and has the ability to manipulate all torque request tables required to achieve 14-16 PSI. My personal car...

Thanks

Found one in another thread. Thanks

Nice! I just got the Holley Hi Ram intake with the new vmp twin jet 67mm TB and curious what gains I will pick up. Just finished the install and...

Hello, Are you able to share the most current tune you settled on? I'm curious to compare your first tune(s) with the current one where you feel...

there is no Suport for Siemens ECU,for dtc delete use buds.

what are you talking about!!!!?

I am almost embarrassed to admit that I thought SD was open loop only!! Physically deleting the MAF is no problem, I would rather not have this...

Meant to post in the v8 section but this will do.