Activity Stream - HP Tuners Bulletin Board

Sort By	Time	Show
Recent Recent Popular Popular	Anytime Anytime Last 7 Days Last 7 Days Last 30 Days Last 30 Days	All All Photos Photos Forum Forums

3 Minutes Ago

Nocupsince93 replied to a thread Injector Data Repository in GM V8 Tuning - Engine, Gas (Gen 3)

The original engine is a L33 (5.3) with the original injectors . I've added a 220-224 cam , intake , headers . When data logging the car I realized...

268 replies | 105891 view(s)

12 Minutes Ago

Zeke started a thread The more I read the more confussed I get in Lounge

I am currently building a '68 GMC Suburban. I have a Gen IV 6.0LS and 6L80, using wiring harness from PSI. engine cranks but that is it. I have a ECU...

0 replies | 6 view(s)

20 Minutes Ago

bk2life replied to a thread gen 3 5.3l cam idle and ve table tunning in GM V8 Tuning - Engine, Gas (Gen 3)

not a time to worry about timing, too many other issues you need to deal with 1st why? What type of driving are you doing? Is this an offraod only...

12 replies | 240 view(s)

20 Minutes Ago

DodgeBoy_8HP replied to a thread 2021 challenger 6.4 barely runs. help in Dodge Tuning - Engine, Gas

I am inclined to believe that Spray-Cam Hell-Ram is correct. John9754, did you change anything on PCM? Harness changes?

4 replies | 157 view(s)

26 Minutes Ago

gametech replied to a thread Can't save edits in VCM Suite General

yes

1 replies | 44 view(s)

33 Minutes Ago

ablitz2020 replied to a thread help with going over tune in GM V8 Tuning - Engine, Gas (Gen 4)

according to the tuner this car runs mint

13 replies | 289 view(s)

34 Minutes Ago

nanygoat replied to a thread gen 3 5.3l cam idle and ve table tunning in GM V8 Tuning - Engine, Gas (Gen 3)

So how's my timing look? I've went by the idle tune info I've gotten from here

12 replies | 240 view(s)

36 Minutes Ago

nanygoat replied to a thread gen 3 5.3l cam idle and ve table tunning in GM V8 Tuning - Engine, Gas (Gen 3)

I was just planning on tuning with the wideband using the ve tables. Its geared way to high for sure thinking of putting a different gear maybe 411....

12 replies | 240 view(s)

58 Minutes Ago

Tom @ Overdrive replied to a thread IM Monitors won't set after very simple tune in GM V6 Tuning - Engine

Should sort them right out. Some monitors wont run without a different one satisfied first.

3 replies | 39 view(s)

1 Hour Ago

dhoagland replied to a thread help with going over tune in GM V8 Tuning - Engine, Gas (Gen 4)

Hard to say... The MAF when using Fuel Trim error (LT+ST) showed 3% lean in a few spots but all in all didn't look bad. Good thing you know how to...

13 replies | 289 view(s)

1 Hour Ago

CTX-SLPR started a thread Log Request: L67 Quick Drive with Specific PIDs in GM V6 Tuning - Miscellaneous

Howdy, I'm trying to figure out what the ECM uses for "in gear" and would like someone with an L67 car to log a quick drive with the PRNDL Status...

0 replies | 9 view(s)

1 Hour Ago

raomaps started a thread Ford Ranger Raptor / Bronco 3.0 US Stock Read in Ford Tuning - Engine, Gas (Ecoboost)

Hello, anyone willing to share a stock tune of either raptor or bronco 3.0 V6 I?m interested in 3.0 V6 2022-2025 bronco or raptor stock tune...

0 replies | 11 view(s)

1 Hour Ago

ablitz2020 replied to a thread help with going over tune in GM V8 Tuning - Engine, Gas (Gen 4)

heres the kicker, it was supposed to be tuned by a paid professional. i could tell it was lean by the plugs

13 replies | 289 view(s)

1 Hour Ago

Formula355 replied to a thread IM Monitors won't set after very simple tune in GM V6 Tuning - Engine

Will this affect the evap monitor setting situation?

3 replies | 39 view(s)

1 Hour Ago

dhoagland replied to a thread help with going over tune in GM V8 Tuning - Engine, Gas (Gen 4)

I'm seeing some pretty good knock retard in log 4 where your really on it. Not sure I'd do too much more of that without a wideband and tuning. ...

13 replies | 289 view(s)

1 Hour Ago

Pistol_91 replied to a thread 2021 Ford F-150 2.7L Eco 10R80 Stock read in Ford Tuning - Engine, Gas (Ecoboost)

Since the last few hours I've been unable to rewrite. Failed to process flash data.

2 replies | 113 view(s)

1 Hour Ago

Tom @ Overdrive replied to a thread IM Monitors won't set after very simple tune in GM V6 Tuning - Engine

You need to turn the cat dtc's back on.

3 replies | 39 view(s)

2 Hours Ago

lxlaw replied to a thread need a 2024-2025 Mustang GT - Dark Horse in Ford Tuning - Engine, Gas (Non Ecoboost, US)

25 replies | 870 view(s)

2 Hours Ago

bleam23 started a thread Pi sedan 3.7 v6 2017 stock calibration in Ford Tuning - Engine, Gas (Non Ecoboost, US)

Hi there, I'm running a 2011 Ford Edge Sport that now has a swapped 3.7L V6 engine from a 2017 Ford Taurus Police Interceptor (VIN:...

0 replies | 17 view(s)

2 Hours Ago

horsepowerguru427 replied to a thread 1999 Chevy S10 5.3 swap won't shift out of first in GM V8 Tuning - Engine, Gas (Gen 3)

I agree with bk2life completely. I did look through your tune and nothing obvious jumped out at me. Put a MAF on and get a log.

15 replies | 180 view(s)

2 Hours Ago

horsepowerguru427 replied to a thread throttle speed? in GM V8 Tuning - Engine, Gas (Gen 3)

Engine>spark>retard>burst knock retard zero these tables out and reintroduce some pedal to the mix. I usually get rid of burst knock anyways....

8 replies | 198 view(s)

2 Hours Ago

dhoagland replied to a thread Injector Data Repository in GM V8 Tuning - Engine, Gas (Gen 3)

This is an 2006 L59 Flex Fuel if that helps. Pretty sure this is returnless... I added a 2003 Flex Fuel I'm pretty sure is return Vac-Referenced...

268 replies | 105891 view(s)

2 Hours Ago

dhoagland replied to a thread Injector Data Repository in GM V8 Tuning - Engine, Gas (Gen 3)

I'm confused What are you starting with? I'm assuming some 25lb injectors and are upgrading to 36lb injectors? In the same engine L59?

268 replies | 105891 view(s)

3 Hours Ago

bk2life replied to a thread 1999 Chevy S10 5.3 swap won't shift out of first in GM V8 Tuning - Engine, Gas (Gen 3)

You are missing the recommendation here. Stick the maf onto the throttle body so everything is hooked up and all your sensors are working...

15 replies | 180 view(s)

3 Hours Ago

ablitz2020 replied to a thread help with going over tune in GM V8 Tuning - Engine, Gas (Gen 4)

here are 3 logs from earlier today.

13 replies | 289 view(s)

4 Hours Ago

epfatboy replied to a thread Is it KNOCK or NOT? in GM V8 Tuning - Engine, Gas (Gen 3)

VBB sorry for the delayed responce, yep checked plugs (finally I know... but I did it) and they did not appear to have detonation signs, again there...

15 replies | 2227 view(s)

4 Hours Ago

mweath10 replied to a thread 1999 Chevy S10 5.3 swap won't shift out of first in GM V8 Tuning - Engine, Gas (Gen 3)

So does anyone see anything obvious in the tune that would cause it to not shift?

15 replies | 180 view(s)

4 Hours Ago

epfatboy replied to a thread Is it KNOCK or NOT? in GM V8 Tuning - Engine, Gas (Gen 3)

FOUND IT... pretty sure anyways. I made what I thought was an un-related change to the Torque Management section for my DBW throttle. For some...

15 replies | 2227 view(s)

4 Hours Ago

Nocupsince93 replied to a thread Injector Data Repository in GM V8 Tuning - Engine, Gas (Gen 3)

I'll apologize in advance as I know that this information is listed in the repository however I do not have access or can't find the tables I'm...

268 replies | 105891 view(s)

4 Hours Ago

epfatboy replied to a thread throttle speed? in GM V8 Tuning - Engine, Gas (Gen 3)

BENEFIT #2... KNOCK RETARD. Was having some issues with knock retard specifically when the TQ is locked and I slowly rolled into the pedal. I...

8 replies | 198 view(s)