Activity Stream

Under Fuel power enrichment table Aircharge and Pratio,

I have an 0411 computer, not sure of the OS at the moment, but I do remember changing some settings so I didn't get full trans pressure in SD mode. ...

Most likely wiring issue… go into VcM controls and “unlock” and lock it, and see what it does

Gametech I hear ya its an old farm truck it definitely has exhaust rattle (exhaust tip banging on receiver hitch), but this noise is internal and it...

The little gear icon above the channels list will allow you to add any channels you want to keep an eye on. Or right click on the channels and select...

how could i log those?

Cantsee much from the log but its not running lean. Youre not logging knock retard or spark advance.

Record a log of trying to start it. Might not be getting enough idle air, what throttle body are you using?

I put 3 sets of these in last week and tooned the trucks with them. They flow the same as the ones we were getting off ebay that were way cheaper. ...

How is your fuel system set up? You have bigger problems other than the injector data if your pressure is dropping that much.

Yea that pressure drop is an issue, i wouldnt worry about scaling till that is fixed.

Got a datalog of it not wanting to shift at WOT and the hot starts? Confirm the ATF level is correct as well.

OEM GM Flex injectors are also a good cheaper option (Buy from reputable source!) , not sure what size is right for your build but there are OEM...

So if I set it to cal and then input the the circumfrance value, it will re calibrated? The circumfrance falls within the min max.

The MAF codes (P0101, P0102, P0103) setting max line pressure can be disabled under Trans Diag, on P01 PCM, OS 12212156, and 12216125 are the ones i...

Rotating Assembly: 417 stroker with TSS rods and DSS -10cc dish pistons (Estimated Static CR of 10.83:1) Cam: TSP 25-TSPL99VVT-3.2 - TSP Stage 3 L99...

Yes i know what FA is thanks , im wanting to know how to adjust the target FA

Fugg yeah! :cool:

You should be able to read your current ecm for free with the software. Once you have your ecm original file bake a backup then open the file in vcm...

Wow, thorough, thank you!

Its my understanding that the knock learn factor is the indicator of which spark table its referencing from. IIRC, when using the high octane only...