Activity Stream

likely kmh to mph for your gauges.

The tuner file is locked. I cannot open it. You have a 606 code which often comes with messing with throttle/pedal tables. If you did. try...

Thank you for clarifying. I have a gen 3 p01 drive by cable engine is a 58x trigger so which harness would I need and goes it matter? 24x...

One can bus to the WB and one to the Can bus on the ski. This can be done through the diagnostic connector as I believe there's an accessory wire in...

I bet there is today, ten years later, LOL

Awesome info Guru, I will get on it and Thank you for all your help so far

So are you connecting the esp32 board to the me17 with a brp square connector? If so, do you have a pinout?

Following ! Tried link also

Ah. Im going to have to look at it when the board comes in. Im sure I will have some questions then. Im with you 100%. Always looking for new...

Is this still the case with the 2022+ CM2450's? Or has a newer version of HP allowed the newer ecm's to be unlocked?

We implemented basically every version we can get our hands on. Unfortunately it's very difficult to get a comprehensive database of stock files. We...

Yes I am logging and making adjustments, here is my latest log run that HAS NOT been applied to my VE table.

thanks again for getting me on this path, im almost to the point of just going for it make some little swings and survey adjust and loop... gonna...

Never mind. I figured it out. Took the class and am good to go.

I'm not getting the status in hpt. It shows the status on the dash as 1 for waiting for trigger, 2 for heating, and when it is a status byte of 3 it...

i guess rich called.... thinking a gross edit to the whole table... x(.9) and run again...

How long has it been?

Your welcome. That's actually how I came up with the idea. I definitely didn't do anything new but I am a big believer in open source stuff and use a...

Then it is something other than VATS.

Thank you sir. I will give those a shot. I did find a few of them myself but most were steady. The Spark TM was the only one that showed anything...

Please put up a link to the hardware. Looks like its 350 bucks from what I see. WF Mcnally took the time to post about a canbus microcontroller...

post the stock file for your truck so I can see if the shift schedules close to the 3.5 if it is the same or similar I have a modified shift schedule...

I was able to read out my personal whipple car today, but does not verify checksum. Not too surprising for a tuned car. I also had a customer...

It happens. Sometimes you just accidentally fat finger an edit, or find an error in previous data collection, etc. ALWAYS keep the last working...

this is nothing new. Dashpac was doing this exact same thing.

but you're not doing it with the MG1 ecu. from what I saw from your videos, you're either using the previous ecu (from the 300) or you're using...

throttle response seems to improved with this flash. i did gather all the info from the modules and the control module for the pump does show up and...