Activity Stream

Trans > Torque Management > Abuse Mode Just one of many many things that could be causing it. It's not like it is possible to diagnose a combo...

I have an LSA setup running on a p01 but I have rectangle port heads. So no adapters. I still run the stock transient tables and have my ve table...

I changed the OS on the tcm and the speedo is reporting correctly now. I also changed the fuel mapping. Took the car for a drive, still cuts out...

for science is a joke. scaling for 2 bar sensor with a 3 bar map sensor isn't a possible work around? and do the NGC4 ecus not have this issue?

do you think there is a Mistake ? or his way of auto scaling ?

Looks like one of our techs gave you 1 thing to try as well as one piece of information to gather if the thing we suggested does not work.

when switching to an injector that will flow more fuel at the same pulse width that your current injector flows, the dead time (offset) (same thing)...

Did you catch the part where his "tooner" drilled a 5mm hole in the TB?

Ive tuned a few with Holley ECU and its much easier getting them to run good. The last LS1 PCM i did with a LSA blower took me a really long time...

2613269 is not a GM operating system, and is also not a HP Tuners custom OS.

It will probably be cheaper to just buy a used T42 that the seller SPS-programs to whatever VIN you supply. All T42s are the same, all service...

Try logging all of the spark advance and retard PID's and see if it shows where the timing adjustment is coming from.

Thank you. For posterity's sake, here is the postWhat I do is go for a drive, set cruise at a speed, higher is better but whatever is safe to set to...

The injector data can be set up for whatever the fuel system type & pressure is... but you'd need to make a decision on what it's going to be and...

I'm sure that you'll make progress once you sort out the fuel system, which means understanding how each type works. Unfortunately your line of...

Hi aaronc7, i have changed the values to standard except for ignition and the limiting values, but the problem is still the same. can you think of...

Your other option would be to buy alphaOBD and use that if HP Tuners isn’t doing it.

There’s a thread somewhere in the dodge section where I explain exactly how to do the speedo correction

What octane fuel?

I will fix that fuel then. Another question. I found a stock 08 Impala tune in the repository. If I purchase the credits and do a full write on...

Ok thank you both for the feedback. Iac and RAF will be revisited but The fuel trims off are also apparent on part throttle conditions So that would...

Then it needs the stock injector data, the kind where it increases as it goes farther to the right. One solid number for the whole table is for...

Below 450mV is leaner than stoich, higher than 450 is rich. Fuel trims aren't active until it goes to closed loop which is usually around 130*F.

My thoughts are, wideband shows rich, idle and off idle, engine is cammed so it is likely even more rich than the wideband is reading, with the cam,...

I got a base tune from A&A when I did mine. Have you asked them for a base tune? Just a thought.... Pjs

Color can be set to whatever you want it to be. Don't rely on color to tell you good or bad. Learn to read the actual data.