Activity Stream

L83, Texas speed stage 2 truck cam, forged bottom, Holley high ram, lt5 throttle body. Was very simple

No problem. Post the tune and log. Here's a good one to go through: https://forum.hptuners.com/showthread.php?110027-Tuning-help

Nah I don't think you touched cam angles. Again, my mistake. If you flatline VCP it will help a lot to do like I mentioned with the cam angles. ...

Your MAP sensor characteristics for the Mopar 3 bar should be: MAP Sensor Linear: 61.05 kPa MAP Sensor Offset: 7.0 kPa MAP Sensor Offset: 0.1001...

There are a few SEP 1000cc class listed for GM applications. Go to their website and find the one that matches yours.

Haha that's because I typed 15248 smh. The 15284 is for 2003-2005. 02, which is the VIN and more importantly OS, is the part you need. Denso over...

how did you buy the interface and the credits ???

@SiriusC1024 Verified sep 1000cc IAT in in intake/charge pipe about 6” from the tb and just after the blow off valve

Wound up buying the DSX aux pump and it is performing wonderfully. Took a bit of trial and error to get the pressure to act right but it is doing...

Yeah it just shows you can't just pick out a piece of another engines tune, plug it into another tune and expect it to work properly because like you...

Have checked the fluid level of the trans? The come low from the factory..

well shoot, it just plugged in!! I went ahead and pulled them both out for a sanity check, but now im not sure what the parts monkey at O'Reilly's...

Get a pair of Denso's for your ECU. It'll work out better for a couple reasons. Fix the wiring of course.

ok, took it for a few laps around the block and let it come up to temp. died on me several times, but you are right, O2 sensors are flatlined. I had...

The Denso is correct (cross-reference P/N is 2344650). The Bosch doesn't belong in there (15896 is called for). How'd you do that? It's a...

I tried submitting a ticket and they told me they do not help with tuning and simply said go to ford and get the latest flash and from what I can...

ok, ill try the tune, im running two different O2 sensors, donor engine only came with one. . . . . probably a mistake :doh: one is a Denso 12562943...

Shoot me a msg, i can help via sct or hpt

Fair bit more work to do on VE, but looks like progress. Interesting that dynair isn't available.

Nah they were flatlined. Maybe try the CL tune and let ECT come up, which means the O2's have heated with exhaust gas (I know they have heaters). ...

Hmmm, I have O2 sensors plugged in, but i suppose its not impossible that I have them wired wrong on my harness, but i thought i was getting readings...

Looks OK by the trims, but there may still be something going on with bank 1. Compare the shape of B1 (spiky) to B2 (smooth). If the O2s are...

Thanks Sirius. I was able to get out and make some logs and SD tweaks using LTFT. Like gametech pointed out, this thing was set up really rich and...

They share the same ground point, but there's more than one wire there, more than one eyelet under the single bolt. G102 should be on the left front...

Well i can say that it is the ground for the driver side coils. Adding a ground directly to the coil wiring did the trick but i have to dig into it...