Activity Stream

I am still Running AP pre-Green speed just to clarify to everyone, Were I live our vehicles are not smogged so no catted down pipes, tgvs are deleted...

I'm still having a little bit of this same issue. A small throttle spike on acceleration. I can see the extra tables in your tune file, but not...

The post above yours tells you how to do it. Reverse the values for primary and secondary tables.

Email sent , thank you.

Gen III engines use black crank sensors with a 24X reluctor wheel, while Gen IV engines use grey crank sensors with a 58X reluctor wheel.

well i dont know what 'regular ones' are, so post your log and then can tell you what, if any, additions are needed.

You just need the pump/sending unit (86825361). No need for the driver, your stock driver works fine. I'm having no issue with E80 spinning the...

For a 100% stock NA 3.6, the Part throttle MAP during light cruise is >80-90kpa. So you're 100kpa with the Ripp isn't that note worthy especially if...

Perfect! Im glad HPT can now locate all those tables in the E90/E99 as well. That lets me spend bandwidth on new avenues! The First 2 are the...

How's the Escalade V pump & module going? I'm considering this as I can't find any other options for more low side flow in the 2019 onwards...

My gladiator 2021 sitting at idle, cams are at 140 and 120. its all stock so far accept for some cooling bods, radiator, trans cooler and oil and...

Thats pretty much the direction I was heading. Keep us posted

Most issues like this are caused by it being to rich in decel. I'd encourage you to use a wideband down near around idle and in decel. The fuel...

The misfire diag won't work with a cam. You might as well not scan that stuff. If you don't disable/de sensistise the misfire counters with a cam...

edcmat-l1, thank you for the information!

Probably more than you wanted to know…. It does go to 0 eventually. Inside the regulator the center of the diaphragm has a ball on it. That fits...

No HPT so no data log….that info was in post 1. Just ordered a check valve, be here on Tuesday.

What’s the trick to get the tcm connector apart to re pin it? I’ve searched hi and low and I haven’t found any write ups on that. I also discovered...

<---- You need to borrow this?

Easiest thing to do is pull the sensor and take a look at the wheel.

^^^ All good points...

I'd rather deal with stage numbers than all the dumb names LOL

here is my first tune any thoughts or suggestions.

Hi, If this does not work do you suggest anything else?

just use this () - () its front wheel speed against future front wheel speed in time, it will show u if ur forward momentum is increasing or...

Can i use Mustang Roush file with this ? Because it has IAT 2

You're wrong. It shows up as downward V shaped spikes. The O2 sensor "sees" the raw O2 from the miss.