Activity Stream

Hey man did you ever figure it out?

A few minutes with Excel and you can have your own easy way to do the vehicle speeds. I made one i can in the tire/gear info and it spits out speed...

Should just be a setting to control either reluctor just like all the other aftermarket ECU's.

Here is a VE table from a centrifugal boosted setup, similar to your end goal.

I’m curious if this removes the need for a lingenfelter 24x to 58x trigger box for older gen 3 ecu’s?

Sounds like your virus protection is working over time. What computer and operator system are you working with? Have you tried selecting the...

It did start; I let it idle for a full 10 minutes. Then I stopped it and restarted, and logged another 3 minutes. The restart was quite good I'd say....

I have been looking for some information on tuning the stock cams for a bit of a boost. Didn't they change the way they were tuned from 21+? I'm a...

These are our Generic channels to start with when tuning Gen V vehicles. If you're doing VVE on a stock cam or VVT camshaft vehicle, you'll need to...

Give this a go to see if it helps at all. If it starts, let it idle for a good while.

https://forum.hptuners.com/showthread.php?56684-Idle-Airflow-config-help I believe if you go closer to the end these configurations will upload to...

good to hear! I will take it out and data log tomorrow. For datalogging, is there a certain amount of time or driving I need to go? I assume a mix...

They are Multec 17113698

Still working on this with limited.. success? At one point I thought I had it, but it seems I don't. My hot start is over 5 seconds (no throttle...

Looks fine. The important things were changed to the 60s settings that I saw. Cylinder displacement is set for a 60. It doesn't reflect the .20...

Stock truck injectors doesn’t really mean anything. Need to get the part number off of the injector.

Use the cobalt as a donor for a DF Goblin kit car.

The only part I guess i don't understand here is how does the race inspectors know whether VVT is working or not? Seems like unplugging it would...

Here is one I had come through a while ago in a 65 Impala with 8 speed trans.

im still new myself but u can try this

The VE will somewhat look like a dyno graph torque curve x RPM. By map it will be somewhat logarithmic

nice catch

youre not. its hard to show emotion when only typing words. take the advice, learn from it, and keep going