Activity Stream

The only reason to stay small on the injectors or stay at the 20% head room rule is cost. The smaller the injector, typically the less they cost. ...

The term "CVN" is not one I'm familiar with. I do know they plug in the OBD II for the states inspection computer. It reads the ready monitor,...

There is a reason people call your state the Peoples Republic of NY. And you never said if they are checking CVNs. There is a YouTube channel called...

CP3 tuning needs handled. You're quite a bit below the desired pressure across the board after 2200 RPM. You're 8000psi down at redline. Timing...

Code it's producing is for open circuit for the VVT solenoid. (which it doesn't have) It's also got one for cam performance and it needs to have the...

This is first thing. Understanding exactly what they're looking for. You can't be vague. Normally if they're only looking for codes/monitors...

i followed the manufacture data templates as a base to begin with. car ran rough then i slowly adjusted the PW vs Fuel Mass tables and inverse until...

Is your ecu unlocked? Either way, technically you're not reading the ecu, what happens is the HPT system detects what ECU and firmware it is, it...

Just an idea, can someone take a quick log with park, reverse, and at least 1st and 2nd gear in drive with the PRNDL and Trans Gear PIDs logged? ...

Original from the 5.7. I think they are 24lb Everything migrated over except the block crank pistons and rods.

Which injectors are used?

I dint have an injector light to test but they must be. Plugs get wet and smells like fuel after too much cranking I went from 5.7 aluminum with...

Most people on here won’t download linked files. They ca N be attached directly in the forum. And you need to post the tune. Have you confirmed...

The "Permanent" code for VVT will be fine. Fix the cam sensor or potential timing issue.

You need to find out if NY is looking at CVNs during inspections or just readiness tests and codes. If they are checking CVNs then nothing except a...

Does this have the stock 4l80 converter? Also it has 3.90 gear? 3.90 and 295/65/15, your speed settings are all a good bit off.

Soooo. I made a file and switched the NN to ENABLED and made a VE table adjustment, after clearing adaptives and still no difference.... So...

what version of hptuner suite are you using and what version of the equipment? Im still using MVP1

sadly it made no change. here is the current tune and log file.

I was just trying to get my timing to do what I wanted it to first then I was going to figure out the fuel. I've decided I actually prefer to leave...

I logged exactly 10 channels. I did not change any frequencies. You'd have to watch the log. Every channel besides RPM just stops and doesn't move at...