Activity Stream

Rob, is there anyway around writing entire with the Beta? Will "write calibration" be available in the future?. Write times right now for the MG1 on...

I was experimenting with trying to make the esp32 respond to scanner requests on the can network to mimic the AEM 30311 because that seems to work...

Ill vouch for FIC(connection) ive always gotten good stuff from them.

1. the attachment wont open. 2. Those 2 logs are the same file lol 3. You need to be loggiing cylinder airmass in channels. This is why your spark...

I was just about to say that. My first tuning experience, I completely forgot why I went with a can capable setup, I also forgot about voltage...

Have you checked the wiring diagrams to confirm where it is getting speeds from? Different applications pull it from and send it to different places....

I just want to clarify this setup is just a "gauge". At no point would I recommend anyone tune bye eye. My setup is no different than any other setup...

Whittlebeast, Let me get on that group. Thank you. So basically the can interface with the wb is necessary to get good data. My original...

As of Beta 5.1.4634, I have not been able to read my stock tune yet, either 'read entire' or virtual. I see there's a new MG1CS055 hardware set for...

please take note of the part that is circled.

I’m in no way saying anything you guys did is wrong. I labeled that as pcmofnc tune just for my records, and I posted it just for information. ...

back to stock idle, flex fuel and dod delete. warmed up: looking at what this ^ is showing thing are back inine.... i dropped in that tune,...

As mentioned above there is more than just "I run a 4.x stroker" to this. Quench, compression, cam, head, porting, fuel injector spec all matter. ...

The issue is, that will only really work a steady load. AFR changes way too fast when information is really needed. Too fast to read by eyes. See FB...

In this first screen shot if look at the line graphs, 4th down, your commanded AFR and actual. I didn't plot ARF error but you can see in the line...

The P0606 is most likely going to be a pedal OS mismatch. It's always best to get the controller/pedal/throttle body out of the same vehicle so this...

Unfortunately I’ve tried to set it to mph, kmh, and even knots lol. Nothing is accurate. It’s strange though because the actual dash gauge is...

From my Experience the FRPP Wiring Harnesses sometimes do cause weird things which make the Gen4X MG1CS019 ECM falling on their face from seeing...

Yes, wastegate was around 70/72% and pedal and throttle was 100%, no limits or correction on them

This!

Thanks for the reply. I think I may be figuring it out slowly lol. Would you mind taking a look at a few tunes and logs to make sure im smoothing...

Deatschewerks or FIC that have good GM injector data.

aslong as the MIL is not illuminated and you have all but one monitor ready itll pass no problem with the permanent code in the history even after...

I'm assuming that other than the cam, your engine is stock. No cat delete, no CAI, no 103mm throttle body, no ported heads, etc, etc. Stock other...

In all reality, if it's running closed loop, there may not be much you can do. I've only tuned half a dozen or so magnuson charged...

i'm using A Corvette Pedal from PSI (acc-1007). I will contact them for settings I wasn't aware that the tuner is locked. I have no idea how to...