Activity Stream

Did you pull the heads and have them repaired/replaced?

The map side of the torque model from what I've seen so far is the only side of the model that the "offset" apply's to. Most people just lower the...

I have that cam in an engine with stock timing chain, cam has 40k engine have about 250k Fires up quickly, drives perfect Use PAC-1218 valve...

Ok what vss can use??

I love Northstars too. I cut my diag teeth on those things in the very early 90s. Come to think about it, I should HATE them LOL

Re-activated closed loop just because you're better off tuning with what the engine will be using. I put some general settings in for long tube...

Some sort of wiring issue, the transmsision codes are all for electrical circuit errors. Got a break the multimeter to find where the problem is at.

Bent them just enough to have a few misfires.

Broke a timing chain? While it was running? And didn't bend all the intake valves?

Ok here's what I have for you first and I'm working on the rest. We looked at the 2018+ Hellcat cam p/n MOP-05038835AA. When we measured it, we...

Alvin's signature:"Tuner at PCMofnc.com Email tuning!!!, Mail order, Dyno tuning, Performance Parts, Electric Fan Kits, 4l80e swap harnesses, 6l80...

TQ tables, trims being 20% off, trans limit...a lot to check. Log TB angle, remove unnecessary PIDs to improve polling.

Is there anything else required to swap to the 0411 PCM? Is it plug and play other than updating the tuen? TIA

That's good news, I prefer the quicker shifts, but the dip in PCS 4 pressure mid shift has me spooked. I've returned the DD table to stock and plan...

Email me directly

no issue as long you know how to do it. cam reluctors has to stay in place

HPT can be in the woods as it comes to crank re learn. If you did that without having code first it might stay there forever as it stays in eeprom. ...

A lot of times with swaps people will neglect to put in all the wiring grounds in the right locations.

After having constant misfires yesterday and reading more last night I am looking into desensitizing the misfire table today, I had a hour errand run...

Me too :) I've always wanted to do RWD Northstar Fbody, SHO swap Ford Probe, 3800 SC in a truck, and Triton V10 in a Mustang or Thunderbird.

I always have been the idiot for unpopular things. Im wierd i love a northstar. I always talked about putting a northstar in something like a 2 door...

Muscle Up do you have some references? Just wondering seems like a fairly new account and posts. Unfortunately with the RTD I can't send you the...

:) tyvm

I found a stock bin for TunerPro but can not find a XDF to be able to view it.

:confused: "kids". I'll never get back that four and a half minutes of this read :doh:

Thank you. I?ll look for a TCC brake fuse and check it out. Also, I will disable all misfires in all tables. Am I correct in thinking that even if...

Your link is broken, but I think you meant this: https://forum.hptuners.com/showthread.php?36318-Idle-Tuning-How-To-amp-Guide-(w-pictures) I'd...