Activity Stream

I?m about to find out. I replaced all the vvt parts and it still does it. I loaded a revised tune with cans set to zero and disconnected the vvt...

#483989

Sounds like a mechanical issue that changing the tune won't help if it is already unplugged. Maybe someone else knows more.

Stock cam angles for N/A are pretty solid. Did you test this on a dyno?

Describe the fuel system with some detail.

Pedal table is driver demand fuel but you also have other tables like friction fuel tables that are part of the equation of the ecm deciding fuel...

Either a 2 bar map with a clamp or 3 bar map with a clamp would be blind above 15psi with timing and fueling adjustments. I'd think the bet would...

Combined with startup flare spark adder table 12643 it is used to produce recognizable exhaust sound.

Still have the phaser. It?s disconnected and I want it to stay parked at all times. I?ve been fighting a situation when the truck warms up, the...

I was going into something else, but things fell through. Still tuning albeit health took a serious hit this last month. Getting better right now and...

All of them...

RaceReadyTuning Heads up that signature is not allowed.

If you are not running the 3 wire ac pressure transducer, need to disable that DTC by setting to No Error Reported. Otherwise the compressor will...

I will check into that. This is a GMPP E67 computer, so there are quite a few things that are different than a standard E67. I know we tried a few...

Well, how about that. It's from a 2000 Chevrolet C7500 Kodiak. I'm sure there are all kind of wiring diagrams floating around for this, ha..... ...

What is your ticket number?

Actually, no, I don't. It's not the same as what's listed on Rock Auto at all. I will have to find out what it's from. It uses the same pigtail as...

i have a question i have a 2022 gtx 300 ltd with IDF, i build the hole engine piston and rods forged head have retainers and springs, my supercharger...

i have a question i have a 2022 gtx 300 ltd with IDF, i build the hole engine piston and rods forged head have retainers and springs, my...

You likely need a new pressure switch and service connector for it. I do these all the time at work (Chevy Dealer)

Depends on if you eliminated the phaser or if the phaser is still installed and what position you want to park the cam angle at.

Jacob It wont pass a visual inspection, and it wont pass the plug in test as the readiness monitor will not set.

youll get more info in the GEN 4 section. but, also, many of us in here are familiar with the things youre asking about, so, if you post a log and...

We were able to request a stock file from Whipple. Flash it to his car using the Whipple device and then o was able to read it from his car using my...

yes I did notice the IAT, forgot to mention that. customer said he found the MAF and MAP sensor wiring were swapped, he is getting it sorted out so...

I'll have to give that a try blindsquirrel. My tach output is set to crank / high:7 / low:8. I appreciate your help