Perhaps I?m missing something. If you tune VE / MASS via our conventional methods to stio, wouldn?t that render the o2 sensor voltage vs mode feature...
Works fine on my Chevy Ecotec I4 LNF/E69. Just some of these will take more effort on your part to figure out. I think I read every post on the forum...
There are better options than to try and make either of these work. The Hellcat pump, if it fits, and it accepts the type of pulse signal from the GM...
Its getting certified for other mods, and as they check over the road legal requirements during this time (mainly by viewing, not digitally tested) a...
Problem solved just needed to edit fuel flow rate in fuel control module, set maximum desired pressure to 400 kpa, see attached photo, fuel pressure...
Hey there, I?m getting ready to set this up. I know this is an old post but I was curious if you got yours to work properly? Just trying to decide if...