Activity Stream

Copy on the afr gauge. I have one sitting now, wish Id have seen your post sooner, much appreciate the work, I havent programmed a microcontroller...

Yeah i talked to tech support last year but honestly its a huge PITA for me because i am not around the ski during the week when TS is there so since...

He lives about 45 min from me. I havent met him in person, but we spoke in private messages a bit when he first started tuning. Im hoping i run into...

It was super nice to just grab the canned profile in channels and plug it up, though. I need to quit being lazy��

Ok, Thats the conclusion Im coming to as well. Tech support know its an issue, I was told it was in the queue so to speak. Any issues with...

All of the horsepowers lol

Do you just need bigger injectors or whats the issues with the current ones? whats the vehicles/engine combo? Cam specs what intake are you...

This isn't our tune. this is just what is needed to get the 4l80 going. Is the wiring all stock? The wiring for VSS are normally a twisted pair...

It will not shift if the VSS is still not working. It shifts by speed. It must have VSS.

You should post the tune and a datalog of it trying to start. Perhaps we can see something you are not and get you on the way.

It's connected directly to the can output of the spartan and then hooked to the can bus of the ski. The board has two can bus circuits one for each...

Have you update the MAP sensor(2/3 Bar)? If so, we need the part number. Heres some basic channels to log... Vehicle speed RPM MAP MAF (if...

When your wheel speed goes to zero (looks like sensor issue) Your rev limiter is set to 5k.

Hi! I have a 4.6L with a mild cam. I would appreciate if you share your tune file, thanks

Also the roush base would be mint!

You can relieve some pressure at the fuel rail with the shrader valve. if it starts immediately after that it was likely vapor lock. If you have...

Better than buying a junky one first and the right one later.

I don't know your cam by part number. is it a 227/243? If so for a GEN 3 this is pushing the limits as to what will get along well in closed...

Will those cal in the attached file work in a cammed 6.2? also is there a preferred order with maf and vve as far as dialing in one before the...

Need a scanner that reads all modules to see for sure.

This is exactly what im thinking. Since the fuel guage hasn't moved, I believe there is some type of hard coding within the bcm that realizes the...

You may try activejetsport's Sea Doo Fueling 101 Tutorial vid. He basically says give the injector offset small adjustments where you want to adjust...

Hi Rick28art! What cables did you mean to connect?

Dude, that's so cool! So the development board is programmed to emulate the OE depth finder, and pulls spartan wideband data from canbus? How is...

Any update on whipple cal S650

99% of them are going to be virtual reads. We didnt want to competely pull back the non-virtual read because its working correctly on every other...

Are you building the VE table based off of logs or are you just pecking at the keyboard in an attempt to make a pretty picture? If what you have...

If VATS is properly disabled you need to diagnose the no start like any other no start. Spark, injector pulse, etc. If it is a stock engine there...

so all the ones that are advertised on fb & the likes how were they read in or out of the car?