Activity Stream

It would be cheaper to buy some AC Delco wires than it would the bulk material and the nice crimp pliers. I build custom wires all the time but...

I went ahead and wrote the tune and started to drive it around looking at the scanner and the LTFT It went from -35 to -32 and then all the way down,...

As far as I know, you should be able to get the correct connector for the coils, but I haven't dealt with those in particular.

i cant open me 2020 ford explorer file look at this

https://www.hptuners.com/mpvi3/

thanks for the reply, what connections would be needed at the coil side? as it seems to contact on the outside and not the inside of the output...

Has anyone made any progress improving the 6F35? I'm looking at things like shifting speed, the rev hang when backing off after WOT acceleration,...

There is a galley plug on the side of the block you can pull and visibly see the dumbell.

This is the Corvette that used the variable speed Siemens module (the one that likes to burn up)? And already has stock settings of PWM Electric...

Tested it If I rise 3-4 speed and lowering 3 TCC Lock speed the tranny locked at 3th in OD But TCC lock is very slow -it cant release TC clutch in...

Anyone having any issues with their tank fitting leaking? Just checking before I pull the trigger on a dsx system

this it the first time i have gotten over 1200 rpms. icy roads here so no drives for a little while and just got the rest of the wide band parts...

Hello All, Newb here. Wanted to say hello! Ive had HPtuner for a couple years but havent used it for its main purpose I purchased it for. Looking...

Log Mass Airflow Frequence (Hz), Mass Airflow, Oxygen Sensor Voltage B1S1, Injector Pulsewidth B1 and B2, and the wideband. Let it idle up to temp...

Hey! Did you manage to fix the problem? The P0765 has been driving me crazy with my Dodge Avenger 2.4l 2008. Tried two solenoid packs, and I don't...

No it's with my tuner, he's trying to debug it too, will try to get on the weekend If the Freq PWM isn't critical, is it like what ??? Said.. E38...

Get a stock reflash from the dealership probably cheapest option

Consider using a VF HSV R8 / GTS file to start with. It will be a bit closer to home given the same engineers worked on both models.

my first tune was done by intense racing and damn was it f***ed up. wideband gauge went straight to lean bypassed all numbers and only had 4 lbs of...

one of your issue is the pcm still flash with an sct tune. Then it wont let you licence it because the vin probably dont match.

I double checked the wiring and reseated the sensor. It didn't make an improvement. BUT I had a thought and double checked the Channel. I removed...

shoot me the file you found in private I should be able to change the vin

Thanks guys! Yes, plan is to dial in the the VVE table with the MAF disabled. Just looking for guidance on the best starting point.