Activity Stream

Ordered fuel pressure tester will know PSI in next day or so. I have a new filter/regulator on-hand, but don't want to change anything until I get...

I just did a couple revisions tonight and have not logged it again yet with the changes. I will load it up tomorrow. Anything you prefer to be...

Logs will help too, so that we can see how it runs with the changes you made.

I appreciate your insight, Sir.

Have you done any tuning with the new turbo?

Hello, I'm also from Wisonsin

If there's only one pair of high speed CAN wires to a module, then it's got an internal resistor. (I had a whole thing already written up here but...

Your 43.0688ci would be a 3.891" bore? Which would be .111" overbore, not .030". The way you deal with the injector thing is, you get the part...

Correct me if I'm wrong, but the max torque tables 1-3 seem to not be in use , as the TQ hysteresis low and high are -7000, so raising or making the...

3.78 + .030 = 3.81 3.81 x 3.81 x .7854 x 3.622 = 41.2942

Whats up brotha, I had this happen to me the other day.. low voltage to the pcm is what I would assume happened and or HPs servers had a hiccup, mine...

Honestly, they don't check the levels, if they do service it, they put back the same amount they take out..

Good thinking - I have not, I’ll have to log and see. It does sound very similar, did you have to do the same thing to get cruise working...

You can raise the startup airflow delay, start with 50 crankshaft revolutions.

Thanks for all the help. I got it to start right up. I don't know if it was just one thing or a combination of things. Below is the list of things...

Thanks. I changed it to 39.

All good Eric. I saw you PM replied but it was blank, can imagine your fairly busy. I'll try take another read of the AU and get you a .hpt

i thought it was an issue with the software or equipment, i was looking to find out the total air flow rate.

and that would explain that explain why its not present in the channel list. thank you!

Got the MAF a little more dialed in. Thanks for the direction. Going to work on VE a little now. Did a light adjustment and some smoothing and...

For some reason he doesn't like to post in the sections for the vehicle he's having trouble with. I don't know if he's made the connection that they...

Thank you guys for your support, seriously people like you are the real asset of forums I didn't tried the OE settings yet however decided to move...

did the write complete or fail? do you have the info.log?

hard for scanner to log a sensor that is not present mopar does not use