Activity Stream

lmk if i'm missing any important data. Up for any tips too, thanks!!

not sure where you are on this as its been awhile but i converted my 98 c5 auto to a p59 and a t56 6 speed with flex fuel sensor and a properly...

Okay that makes sense, thanks. I went to Engine > Fuel > Oxygen Sensors and then under closed loop enable I changed all coolant temps to 275F. ...

Ridiculous. Everyone knows you lay them sideways and knock the tops off with a plasma cutter, lol.

And NO I wouldn't actually shorten the piston tops with a belt sander, that was clearly a joke. I'd build a fixture and use the wood router. Duh.

No, block would have to be honed and if I was gonna pay money to have one honed it'd be one of the spare 350 blocks I have. I did see someone try...

So what rings should I put in it, asshole? Post in this thread again and I'll report it.

wouldn't he also need to open up the ring lands for his used cast rings?

I agree.. Unplug the oxygen sensors or disable CL all together. Then reset Fuel trims and it will be ok to cruise to exhaust shop.

Hi mate, I?m having the same issue with an LS1 in a Nissan patrol. Car ran fine, stopped, found no 12v from ECU to the crank angle sensor after...

Too bad those Honda pistons you were talking about have small pin bores. Could have just figured out how to lathe off a few thousandths to fit your...

I'm working on a 2002 escalade 6.0 v8 awd. Truck norris cam

When I go to read the machine, I have to manually enter the vin. I do that, then click ok. No OS pops up, I click read. It says it read it, but...

Not all cars/trucks from every manufacturer across all years are the same. You did not mention what you are working on, even.

You can't run closed loop with O2 feed back with open headers. Either change the closed loop enable temp really high in the tune so it stays in open...

No, since there is no exhaust, the pipe is full of oxygen skewing your O2. Need some exhaust on it if you want to use the narrowbands, preferably...

You will need to have the tune sorted out for whatever RPM/Boost your going to see on the 2 step settings. Say your at 3000 rpms and 6psi. Make...

Will your dyno tuner be able to supply you with a startup tune?

Its funny how that works..

Post your tune.

Torque management settings are maxed in both tunes. Today we studied this with 3 different P59 PCM units. Holden 2006 (my own) Service number...

These stock GM pistons already in the block measure .174" from the deck down to the bottom of the dog dish. That means something needs to shove the...

On hp tuners vm editor.

On what? Did you try turning it off and back on again?

No, he never did. No one even replied to this thread with suggestions.

you find your answer?