Activity Stream

would you okay it to do the 25-30 minute drive directly to the tuner as is?

Id fix my IAT issue and do a little "self tuning" to clean up the fueling before i took it anywhere that far. COULD it make it that far? Probably so,...

No, the rear sensors are technically not required to keep the cats. Just have to set the codes correctly for them and it's really not an issue. ...

I over revved a stage 4 high ram build. Spun the bearing on purpose. 6500 rpm max on the log. Also had too much timing and too lean at 21* and .82ish...

Same with the trucks?

your input has been extremely valuable. I thank you very much. As to why i dont just tune it myself... time. I work for myself with no employees or a...

I just saw that. I'll look into it. Could have been I was cranking it for too long. I'll put a booster on it and see if that changes.

oops move this thread to gen 5 please

Startup wasnt logged in that file. Youre not showing knock anywhere. Also running pretty rich everywhere, better than lean if youre not tuned.......

does this show whats needed? i did note that it was hard to start when i went out just then, never done that before.

I'm looking at this trigger in my 2015 Hellcat right now. What is the effect of enabling this? Can you put the car in burnout mode? Currently I've...

added, going for a ride now. Will return shortly

Wanna be safe? check it for knock. Doesnt take long to add a channel and roll around the block. after you add cylinder airmass to channels and start...

Dude, you?re the MAN, you replied quickly to me last night too. I?ve actually just found a tuner that?s only 13 miles (25 minutes) would you feel...

The IATs arent ideal but theyre not crazy. I get the same numbers in traffic in most of my vehicles. Youre only filling the first row of cells for...

no worries :cheers:

sorry,,,, Yup wrong section

Youre using a GEN IV computer and setup. This is GEN 3 threads. Post in...

You think it'll run on trims? I just figured it was a unanimous vote that with a cam that big OLSD was the way to go. I wouldve kept the MAF if it...

Yeah I see you have to be logged into both tuner tools and website customer portal for it to work . Thanks

Heres another log. "cold start" (its like 90F lol) I reset all IAC values back to the stock WS6 file. Along with BRAF +4g/s across the row. Idle...

Thanks I’ll give it a go