Activity Stream

Here is that file with those several adjustments we were messaging about. Not sure how your trans is acting currently but I added that in there as...

Is this a new install of the after market box or has it functioned normally for some period of time? Supply the config. file and a log of the...

Are these numbers accurate for cam specs? 392 6.4 VVT 215/221 @ .050" .353"/.333" lobe lift .574"/.541" valve lift 121 LSA 108 ICL Stock...

What's your elevation above sea level during this log! Was the accelerator pedal every at full throttle or is the TPS accurate? At first glance...

That is interesting. Have you tried to 0 the steering angle with a scanner?

I would recommend getting used to the lambda scale.

Ok, cool. Did a start today but nothing logged, leaving at o?dark thirty tomorrow morning for another work trip but should be back Saturday. Have a...

I wonder why they won't let you change the VIN though. Do the newer OSes change the pinouts or something? Or can't talk to the old ABS/SRS?

Don't worry, I know what you mean haha. Looking at your log, your lean tip-in settles down around 219*F IVT (I'm keeping the values as per HPT...

Oops Thanks

Nope.

I like how my question was never answered.

Well that's an angle on it and sorta my way of thinking. If i'm going to be in there, might as well try to optimize things without overdoing it....

Copy and paste your original post here along with the files. Let the other one die.

i believe i traced it back to when i did the abs delete. i shut off the U1040 code. other than that nothing was changed. ill have to wait to change...

Nope. 14.68/1.160 = 12.65. That's the EQ ratio for PE.

Probably will help if you post the tune file too. And give a complete breakdown of parts used, like intake, throttle body, injectors etc etc etc....

when I Change the values to 95% there is a big drop off on the graph to the right. Should I smooth out the complete graph?

Cam is in, crank is in and torqued to spec (105 Ft/Lb) in 3 stages. I also installed the #5 cap o-ring and put a touch of sealer at the edge where...

What did you swap it into to?

But that .80 lambda goes away once you warm up a bit right? Do you have it tuned to command 1.00 on cold start? It should run rich for easier cold...

Full MAF is why. Dynamic mode re-enabled since MAF is mapped out now. Increased VE bias. Try it out.

I am having the same issue. I was able to read files from my Cts V and from my 94 G30 with a Lq4 swap. I was data logging with the V no problem. I...

Yeah. You can go above 4k. Don't do WOT.