Activity Stream

When I go to read the machine, I have to manually enter the vin. I do that, then click ok. No OS pops up, I click read. It says it read it, but...

Not all cars/trucks from every manufacturer across all years are the same. You did not mention what you are working on, even.

You can't run closed loop with O2 feed back with open headers. Either change the closed loop enable temp really high in the tune so it stays in open...

No, since there is no exhaust, the pipe is full of oxygen skewing your O2. Need some exhaust on it if you want to use the narrowbands, preferably...

You will need to have the tune sorted out for whatever RPM/Boost your going to see on the 2 step settings. Say your at 3000 rpms and 6psi. Make...

Will your dyno tuner be able to supply you with a startup tune?

Its funny how that works..

Post your tune.

Torque management settings are maxed in both tunes. Today we studied this with 3 different P59 PCM units. Holden 2006 (my own) Service number...

These stock GM pistons already in the block measure .174" from the deck down to the bottom of the dog dish. That means something needs to shove the...

On hp tuners vm editor.

On what? Did you try turning it off and back on again?

No, he never did. No one even replied to this thread with suggestions.

you find your answer?

Thanks for the details. When I put the turbos on I bought new hellcat 660cc(?) injectors. I can put them back in and maybe possible start tuning over...

I agree 24x and CNP is far superior. This is solely for my own interest and learning purposes. This is for a race/events car so I am willing to try...

That's interesting. I don't think I've ever ran into one of these setups. And there's a lot more wrong with the opti than just the optical...

To add, car also has cams and a bunch of other stuff. I've recut virtual VE model as you would expect. Trims are reasonable. BUT without an engine...

Hi Rob - ticket Re: Mk3 Focus RS - Missing logging PID - #488572

If you send a ticket we can get it added (it should already be there but we can investigate). I'm not sure I understand what you mean about it...

Because after I looked at dozens of YouTube videos, and them never doing it, I figured that was the correct way because of the references. I mean tdc...

Rob - thanks for reply. I get what it is and how it's calculated. But unless we can see the actual pulse width or max angle vs actual it's still an...

These valves are, surprisingly, heavier than LS 2"/1.55". LS IN 100.2g 267 IN 107.9g LS EX 85.8g 267 EX 99.2 Because of the lower rocker...

My best guess is that the only "simple rule of thumb" scenario would only apply to common parts, such as are used on factory motors that came with...

If you told me water was wet I'd have to check before I'd believe it.

In actual practice no not yet because the cylinder heads aren't installed yet. But seriously, yes and no. Yes, because with such a small...

I have a 2014 ( early model gen v, looks like the 2015) l86 and 6l80. I have ordered an L8P. Can I re use my accessory drive kit from the l86 or do I...